What does PIP Code 14 mean on Ford EEC IV?

What does PIP Code 14 mean on Ford EEC IV?

Heat Is Your Enemy!: The top three leads (for PIP signal) can lose continuity with the back plate (ground) on the module when the unit is hot. You should consider a remote mounted TFI. If your TFI is failing from heat, it can give off computer codes 14 (PIP) and 18 (SPOUT).

How to read FORD OBD diagnostic trouble codes?

No Heated Oxygen Sensor (HO2S) switching detected (front – HO2S) If using 12Vdc circuit test light, pay careful attention to length of pauses in order to read codes correctly. If using MIL/CHECK ENGINE light, service codes are displayed as flashes. Connections are displayed in image.

How to troubleshoot Ford EEC IV engine control?

Place the gear shift lever in Neutral (manual transmission) or Park (automatic transmission). CAUTION – Failure to perform this step may result in the vehicle moving when the starter is subsequently engaged during the test. 2 – Disconnect the S terminal wire at the starter relay.

What is the spout signal on a Ford EEC IV?

Here is a picture of SPOUT (Spark Output signal) wire that was grounding out. The yellow spark output signal wire is without a section of insulation. This section happens to run through a shield ground that provided a convenient ground source for the SPOUT signal.

Can a Ford Explorer engine control computer malfunction?

When it comes to style, versatility and safety, your Ford Explorer is second to none. Getting the most out of your SUV means making sure your engine control computer isn’t malfunctioning and keeping your Explorer from starting right away. Replace your current one with a new Ford Explorer engine control module from AutoZone today.

What’s the trouble code for a Ford engine?

Trouble Code. Fault Location. Probable Cause. P0171. Fuel trim (FT) system too lean, bank 1. Intake/exhaust leak, AIR system, MAFNAF sensor, fuel pressure/pump, injector (s), HO2S. P0300. Random Cylinder Misfire (Cylinder Not Specified) Spark plug (s), HT lead (s), injector (s), ignition coil (s), low compression, wiring.

Where are Ford code 11 and 12 located?

Record all codes received. Turn ignition “OFF”. Ford DTC’s (Diagnostic Trouble Codes) Data Link Connector (DLC)(Located Under hood) Analog Voltmeter Connection Ford Codes 11 System PASS. 12 Cannot control rpm during KOER Sell-Test high rpm check.

What is the OBD2 code for a Ford?

OBDII Ford Code Definitions. Be sure to double check the codes. Anything P1000 to P1999 or P3000 to P3400 will be Manufacturer specific and may not match the ones listed here. Check specific manufacturer pages on the site, as some of them, we list the OBD2 codes on those pages for those specific vehicles.