Easy tips

What does p0172 Chevy engine control module mean?

What does p0172 Chevy engine control module mean?

P0172 CHEVROLET Meaning The Engine Control Module (ECM) controls the air/fuel metering system in order to provide the best possible combination of driveability, fuel economy, and emission control. Fuel delivery is controlled differently during Open Loop and Closed Loop.

How to fix p0172 Chevrolet fuel trim system rich bank 1?

How do I fix code P0172 CHEVROLET? Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. How much do you know about cars? What does this mean?

What causes p0172 and p0175 DTCs to set?

If the extreme Rich Condition that’s causing the PCM to cut fuel to its maximum limit is present, you’ll see the Long Term Fuel Trim values of one or both banks stuck somewhere around -20%. Remember, an uncontrollable Rich Condition is the one that causes P0172 and/or P0175 DTCs to set.

How much does it cost to repair a p0172 Chevy?

The cost of diagnosing the P0172 CHEVROLET code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.

What does fault code p0172 and p0175 mean?

P0172/P0175 Diagnostic Theory for Shops and Technicians. When a vehicle has the fault code P0172 and or P0175, it means that computer can no longer automatically adjust the mixture between air and fuel. Code P0172 applies to Bank 1 and P0175 applies to Bank 2.

How much does it cost to diagnose p0172 Chevrolet code?

The cost of diagnosing the P0172 CHEVROLET code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour. When is the P0172 CHEVROLET code detected? – Fuel injection system does not operate properly.

What causes the Check Engine light on a GM 4.3L?

Since the PCM is reducing fuel, the LT Fuel Trim (Long Term Fuel Trim) values will go into their maximum negative Value of -20%. If this Rich condition continues, without switching to a Lean condition, for too long… the PCM lights up the check engine light and reports a P0172 or P0175 (depending on the bank that’s being affected).

What causes a Chevy Malibu to misfire code p0172?

Here are the typical symptoms that something is wrong when you have code P0172. Mileage- may or may not suffer depending on how much the air fuel mixture has changed. Misfire – If the air fuel mixture has gotten too far from factory specs, this can cause the Malibu to misfire.

Is it okay to drive a car with p0172?

It is okay to drive a vehicle with P0172 for a short period of time, but driving with this code for an extended period of time can cause internal engine damage and failure of the catalytic converter. Code P0172 Common Diagnosis Mistakes It is important to complete the entire diagnostic process when diagnosing P0172.

What does the p0172 Chevrolet engine code mean?

Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. What does this mean? The cost to diagnose the P0172 CHEVROLET code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type.

What causes the p0171 code on a Chevy Malibu?

There are many things that can cause the P0171 trouble code on the Chevy Malibu. Here are the most common ones. Vacuum Leaks – With the Chevy Malibu, one of the most common cause for the P0171 code to show is a vacuum leak. Take a look around and see if you can find the vacuum leak.

What is the trouble code on a Chevy Malibu?

A common trouble code with the Chevy Malibu is P0172. This code number references a number that is given to you when you plug your car into a OBDII scanner. It’s not the most complicated OBDII trouble code to diagnose.

How do I fix code P0172 CHEVROLET? Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. How much do you know about cars? What does this mean?

What happens if the p0172 code is too rich?

If the the air-fuel ratio is rich enough, a black smog will come out of the exhaust, which is harmful to the environment. What repairs can fix the P0172 code? It is highly recommended to check the condition of the spark plugs and the operation of the coolant temperature sensor. Need help with a P0172 code?

What does Bank 1 mean in engine code?

The “Bank 1” portion of this code indicates that the problem is concentrated on the side of the engine that includes the #1 cylinder. Since inline four cylinders only have one bank, the one bank they do have is considered bank 1.

What causes the p0172 code on a Chevy Silverado?

The P0172 code on a Chevy Silverado will often be thrown if the fuel injection system is not operating properly. Typically the code will be triggered by a rich condition in the engine. There aren’t usually any drivability issues associated with P0172.

What does the DTC code p0172 stand for?

Diagnostic trouble code (DTC) P0172 stands for “Fuel System Too Rich (Bank 1)”. Your car’s computer will set the code when it determines that there’s too much fuel (or too little oxygen) in the engine’s air-fuel mixture.

Is the p0172 fuel injection system too rich?

P0172 with P0175 or MAF DTCs – If you note both P0172 and P0175 or concurrent MAF-related DTCs, then you can likely rule out individual cylinder, ignition, and fuel injector problems. Instead, focus on the fuel injection system and the MAF.

What does it mean when your ECU says p0172?

P0172 indicates that there is too much gasoline being detected in the exhaust gases exiting the combustion chamber. The ECU uses a number of instruments, such as the mass air flow sensor (MAF), oxygen sensors, and manifold absolute pressure (MAP) to monitor the air-fuel ratio of the engine.

Why do I have a p0171 code on my car?

The P0171 code could also be caused may be caused by one or more of the following: debris on MAF sensor causing an incorrect reading, improper oil level, low or high fuel pressure or Engine Control Temperature (ECT) Sensor reading inaccurate.

How much does it cost to diagnose p0171 Chevrolet fuel injection system?

The cost of diagnosing the P0171 CHEVROLET code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour. When is the code detected? – Fuel injection system does not operate properly.

Why is my p0172 system too rich bank 1?

Check for an exhaust leak before the first oxygen sensor (this is unlikely to cause the problem, but it is possible) P0171 is showing on scanner but not a service light on , then after about 30 miles p0172 go’s active and turns service engine light on . Seems like it’s running fine ,but cannot get anyone to figure out the 172 code rich bank 1 .

How much does it cost to diagnose a p0171 Chevrolet code?

The cost of diagnosing the P0171 CHEVROLET code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour. When is the P0171 CHEVROLET code detected? – Fuel injection system does not operate properly.

What are the possible causes of p0172 Chevrolet?

P0172 CHEVROLET Possible Causes Faulty front heated oxygen sensor Ignition misfiring Faulty fuel injectors Exhaust gas leaks Incorrect fuel pressure Faulty Mass Air Flow (MAF) sensor What does this mean? How do I fix code P0172 CHEVROLET Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors.

How does the p0171 Chevrolet fuel trim system work?

Excessive Fuel Consumption P0171 Chevrolet Description The Engine Control Module (ECM) controls the air/fuel metering system in order to provide the best possible combination of driveability, fuel economy, and emission control. Fuel delivery is controlled differently during Open Loop and Closed Loop.

When to use lean condition code p0171?

Combustion engines run most efficiently when they maintain an air-fuel mixture ratio of 14.7 parts air to 1 part fuel. When there are more than 14.7 parts air to 1 part fuel in the air-fuel mixture, a lean condition exists and code P0171 is triggered.

What happens if your DTC p0172 goes into limp home mode?

Depending on the nature of the failure, DTC P0172 may or may not be accompanied by drivability issues. At the very least, you will experience poor fuel economy, because, with the ECU in “limp-home mode,” it is no longer looking at HO 2 S and AFR sensors for feedback.

What causes air flow code p0172 and p0175?

The fuel mixture grows rich and eventually, the code sets. An “over reporting” Mass Air Flow Sensor can be a common cause of a code P0172 and P0175. Essentially, this means that the Air Flow Sensor is telling the computer that much more air is entering the engine than actually is.

Author Image
Ruth Doyle