What does Ford diagnostic code p1408 stand for?
What does Ford diagnostic code p1408 stand for?
Ford Code: P1408 Definition: Exhaust Gas Recirculation (EGR) Flow Out Of Self-Test Range Description: This DTC sets when the exhaust pressure (EP) sensor value is above or below the calibrated level when the EGR valve is commanded open during the key ON, engine running (KOER) self-test. Cause: Aftermarket intake systems or exhaust systems
What is the p1408 fault code for EGR?
P1408 fault code and how to check the egr valve system including how to clean the egr valve exhaust internal flow. This fault code P1408 is an egr (exhaust gas recirculation) valve circuit failure.
How much does it cost to repair a Ford p1408?
The cost of diagnosing the P1408 FORD code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
What is the p1409 code?
Error Code P1409 is defined as EGR Vacuum Regulator Solenoid Circuit Malfunction. This error code refers to a test to check the electrical function of the EGRVR (Exhaust Gas Recirculation Vacuum Regulator) solenoid.
What does emission code p1409 mean?
P1409 Meaning This test checks the electrical function of the Exhaust Gas Recirculation Vacuum Regulator (EGR VR) solenoid. The test fails when the EGR VR circuit voltage is either too high or too low when compared to the expected voltage range. The EGR system must be enabled for the test to be completed.
What does a diagnostic code P1401?
P1401 Diagnostic Module – Tank leakage , (DMTL) System Malfunction. With this code condition the DMTL air pump motor current draw is higher or lower than expected, Water has been known to enter into this pump where the elbow connection has to be removed and inspected for. Hyundai has produced a TSB for this condition TSB #00-30-002.
What does code p0402 mean?
What the P0402 code means. P0402 is an OBD-II generic code that the engine control module (ECM) has detected indicating the engine exhaust gas recirculation ( EGR ) valve is flowing too much recirculated exhaust gases when it is commanded to open the flow of gases into the intake manifold.
