What does diagnostic code P0700 mean?
What does diagnostic code P0700 mean?
Transmission Control System Malfunction
P0700: Transmission Control System Malfunction. The OBD-II scanner error code P0700 problem is a generic code that applies to vehicles equipped with OBD-II. It refers to the transmission control module (TCM) in the automatic transmission. You may be seeing poor gas mileage or have transmission shifting problems.
What does p0700 mean on a Dodge Avenger?
The ECM stores the P0700 code and it means the TCM detected a malfunction with the transaxle controls. 2008 Dodge Avenger. 4cy 115,000. Have the same problem. Changed solenoid pack. And nothing again. The worst way to get any suggestions is to do as you have.
When to test 2 / 4 solenoid on Dodge Avenger?
The 2/4 Solenoid is monitored at initially power-up, then every 10 seconds thereafter. The solenoids will also be tested immediately after a gear ratio or pressure switch error is detected. Since the P0700 is just and informative code, check the TCM for more codes to resolve the problem.
What’s the transmission code on a Dodge Avenger?
The magnet had very little particles on it. The code still came up as p0755 and p0700. I reset the computer by unhooking the wires and touching the two together it ran for about 15 minutes then the gears went back down into 2nd and wouldn’t shift out again.
Why does my Dodge Avenger not shift gears?
Mine is the 6speed. Transmission will not shift gears. The 2/4 Solenoid is monitored at initially power-up, then every 10 seconds thereafter. The solenoids will also be tested immediately after a gear ratio or pressure switch error is detected. Since the P0700 is just and informative code, check the TCM for more codes to resolve the problem.
The ECM stores the P0700 code and it means the TCM detected a malfunction with the transaxle controls. 2008 Dodge Avenger. 4cy 115,000. Have the same problem. Changed solenoid pack. And nothing again. The worst way to get any suggestions is to do as you have.
The 2/4 Solenoid is monitored at initially power-up, then every 10 seconds thereafter. The solenoids will also be tested immediately after a gear ratio or pressure switch error is detected. Since the P0700 is just and informative code, check the TCM for more codes to resolve the problem.
The magnet had very little particles on it. The code still came up as p0755 and p0700. I reset the computer by unhooking the wires and touching the two together it ran for about 15 minutes then the gears went back down into 2nd and wouldn’t shift out again.
Mine is the 6speed. Transmission will not shift gears. The 2/4 Solenoid is monitored at initially power-up, then every 10 seconds thereafter. The solenoids will also be tested immediately after a gear ratio or pressure switch error is detected. Since the P0700 is just and informative code, check the TCM for more codes to resolve the problem.
