What do you need to know about limp mode on Ford Escape?

What do you need to know about limp mode on Ford Escape?

As already stated there should be codes generated whenever your car goes to limp mode. These are Federally Mandated Generic codes that any $30 scanner can pick up. No need for expensive scanners for “Limp Mode” code retrieval. Secondly, there is a SSM (Special Service Message) for False MIL when restarting after remote start time out.

What’s the low coolant light on my Ford Escape?

Last Friday I was driving my 2013 Ford Escape 1.6L EcoBoost to work. Not even a mile from my house the “low coolant light, service required” light came on, directly after that I had an “Engine reaching high-temperature warning” come on and the vehicle went into limp mode.

Is there a problem with my Ford Escape?

If its not leaking out side the motor, than it burning it internally. This is a far more serious problem. If this persists I would tell your dealer you want them to test the cooling system for hydrocarbons. This will tell you if you have a cylinder/head gasket integrity problem. I have a 2013 Escape SEL AWD 1.6L ecoboost with ~21,000 miles.

How many miles does a 2013 Ford Escape have?

I have a 2013 Escape SEL AWD 1.6L ecoboost with ~21,000 miles. Purchased it used. 2 weeks after I purchase taking 100 mile trip which most of it was turnpike drive at 65-70 miles per hour.

How many miles does a 2013 escape have?

We have a 2013 Escape with the dreaded 1.6L engine. It has 11,200 miles and this problem has happened 4 or 5 times. The last two times was within 10 days and 200 miles.

Is there a recall on the F1 escape?

F1 Recall 13s12 was completed. Go to F2 F2 DTC U1035 retrieved. Go to F3 F6 .6 ohms. Install new coolant stand pipe. R&R coolant stand pipe. Test drove vehicle and code didn’t come back. 200 miles and 10 days later the same thing happened. F2 Cleared DTC and no DTC returned.

What’s the VIN on a’13 escape’?

The VIN is 1FMCU9GX8DUD70681. I checked the battery terminals and other electrical connections in the engine bay and all appeared tight. I couldn’t find a similar problem by searching the forum threads. The overall unreliability of this Escape has me unwilling to get very far from home with it.

What’s the build date on a 13 escape?

The build date shows 5/13 on the door post placard. The VIN is 1FMCU9GX8DUD70681. I checked the battery terminals and other electrical connections in the engine bay and all appeared tight. I couldn’t find a similar problem by searching the forum threads.