What do you do if you lose your tent poles?
What do you do if you lose your tent poles?
The easiest and quickest way to fix a broken pole is with a pole repair sleeve. Also called a splint, this short tube is often provided with your tent. If not, buy one and pack it with you. A good pole repair sleeve is just slightly larger in diameter than your pole so that it doesn’t move around too much.
How do you measure a tent pole replacement?
To work out the diameter you need you can use a vernier calliper if you have one, or, a tape measure if not. To measure with a tape measure you need to remove a section from your pole, lay a tape measure or ruler on a table and put the section, end down, on to the tape measure. Now read the diameter.
How do you remove a ferrule from a tent pole?
Care must be taken not to over heat as you will burn the pole. On site, you can put it in a mug of boiling water to soften the glue then use a bit of brute force + pliers. But tbh, it’s easier just to buy an entire replacement pole section and cut down the non-ferrule end to give the correct length.
Can I cut a fiberglass tent pole?
Re: Advice on cutting fiberglass tent poles? Definitely, a simple hacksaw. You need one anyway, if you don’t have one. Put a few loops of masking tape around where you want to cut, do it outside, it’ll take 3 minutes.
Should I put a tarp under my tent?
Putting some sort of ground cover or tarp under your tent is essential for the durability of your tent and to keep it warm and dry. If the tarp extends too far, even dew will run down the tent walls and collect under your tent. When camping at the beach, don’t put a tarp under the tent, but rather inside the tent.
Can I put a tarp over my tent?
While you can drape the tarp over the tent, it’s better to suspend it over the tent. Also, always be sure that you purchase a tarp that is large enough to cover the tent, but small enough to suspend between two trees. When suspending the tarp, always be sure to hang it at a slightly slanting angle away from the tent.
How do you fix a bent aluminum tent pole?
The only way to soften the aluminum is to anneal it, which involves heating the aluminum almost to it’s melting point and then letting it cool slowly, but if you try to do that then your pole will be so soft that it won’t flex, it’ll just bend like welding wire.
How thick should a tarp be under a tent?
How Thick Should A Tarp Be Under A Tent? There’s no minimum thickness for ground cloths, however, anything thicker than about 2mm should be sufficient. Do keep in mind, though, that the thicker your tarp, the heavier and bulkier it is in your pack.
How do you keep water from pooling under a tent?
Always use a large ground tarp under the tent as a barrier to moisture seepage from the ground – even if your tent is waterproof. Ideally, you should own a tent which includes a waterproof rain shield or large rain fly. If not, then you will need to hang tarps with ropes attached to trees or poles.
Do you need to make your own tent poles?
We carry everything you need to make or repair your own aluminum, carbon fiber or fiberglass tent poles. It is very easy to make or repair your own poles and save a lot of money doing so
Do you need to replace a trekking pole section?
Sounds like you need a new section. Contact the mfg with a replacement. For some poles, you can buy replacement “plugs”. If the threads are stripped on the plug, replace that. If they are stripped on the pole section, you’ll need a new pole section. I’m a bit surprised that this is news.
How big is a quest fiberglass tent pole?
TENT POLES & PARTS Click on a size below to see all of the poles, endtips & other parts for each size HOW FAR WILL FIBERGLASS POLES FLEX? DO YOU HAVE A QUEST TENT? .370″ . .370″ .
What’s the best way to shockcord tent poles?
For your ring and pin system the best way to shockcord the poles together is to tie the shockcord onto a small washer that is just slightly smaller than the inside diameter of the tent pole. When the washer is pushed up into the pole the insert on the first pole will stop it from going past.
What do I need to replace my tent pole?
It also includes two replacement vinyl pole caps that make for easy adjustment of the shock cord.
TENT POLES & PARTS Click on a size below to see all of the poles, endtips & other parts for each size HOW FAR WILL FIBERGLASS POLES FLEX? DO YOU HAVE A QUEST TENT? .370″ . .370″ .
How big of a shockcord do I need for a tent pole?
The standard size shockcord for most aluminum and carbon fiber poles is 1/8″ (our item #2400) but when weight is more critical you can use 3/32″ shockcord (our item #2402). The standard size for fiberglass is the 3/32”.
What’s the best way to shockcord a pole?
How to shockcord poles together without using endtips- (ie. ring and pin system): For your ring and pin system the best way to shockcord the poles together is to tie the shockcord onto a small washer that is just slightly smaller than the inside diameter of the tent pole.
