What are the symptoms of engine code p0014?
What are the symptoms of engine code p0014?
So, P0014 refers to over-advanced timing of the camshaft in the bank containing cylinder 1 and that is in the exhaust, rear or right position. What Are the Symptoms of Code P0014? A problem with timing in the engine will cause it to run rough. You may experience hard starting, poor idling, and/or engine stalling.
How to find the p0014 position on a camshaft?
Type A code there is something else. P0016, P0017, P0018, P0019, P0335, P0336, P0338, P0341, P0342, P0343, P0346, P0347, P0348, P0366, P0367, P068, P091, P092, P093, P0521, P0522, P0523 If the initial P0014 sets and other codes are present then erase all codes and do five camshaft drive cycles and then re-investigate which codes come back.
How much does it cost to repair a p0014 Chevy?
Cost of diagnosing the P0014 CHEVROLET code Labor: 1.0 The cost of diagnosing the P0014 CHEVROLET code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour. P0014 CHEVROLET Possible Symptoms
Why does my Saturn Outlook have a p0014 code?
If the valve does not respond to the criteria of the computer, it will recognize the algorithm. So, usually when the P0014 code shows it is failure due to lack of maintenance. Most P0014 codes are almost always a result of bad oil changes and lack of car maintenance in regards to engine lubrication. 2007 Saturn Outlook 3.7. 140000 miles.
What are the possible causes of a p0014 Chevy?
P0014 CHEVROLET Possible Causes. Dirty Oil. Low engine oil level. Faulty Exhaust Camshaft Position Actuator Solenoid. Exhaust Camshaft Position Actuator Solenoid harness is open or shorted. Exhaust Camshaft Position Actuator Solenoid circuit poor electrical connection.
Type A code there is something else. P0016, P0017, P0018, P0019, P0335, P0336, P0338, P0341, P0342, P0343, P0346, P0347, P0348, P0366, P0367, P068, P091, P092, P093, P0521, P0522, P0523 If the initial P0014 sets and other codes are present then erase all codes and do five camshaft drive cycles and then re-investigate which codes come back.
What causes an OBD-II scanner error code p0014?
If you experience an OBD-II scanner error code P0014 problem, there can be a few possible problems causing it. The following are the most likely causes: The problem can also be caused by a faulty PCM or ECM inaccurately throwing the code. Although there are a few possible causes of the code, it is a relatively-specific error.
How is the camshaft position ( CMP ) actuator solenoid controlled?
The Camshaft Position (CMP) actuator is attached to each camshaft and is hydraulically operated in order to change the angle of the camshaft relative to Crankshaft Position ( CKP ). The CMP actuator solenoid is controlled by the control module. The control module sends a pulse width modulated 12-volt signal to a CMP actuator solenoid.
