What are the symptoms of a bad shift interlock solenoid?
What are the symptoms of a bad shift interlock solenoid?
Symptoms of a Bad or Failing Shift Interlock Solenoid. The shift interlock solenoid is a safety mechanism that keeps the driver from shifting out of park when the brake pedal is not pressed down. In addition to the brake pedal being pressed down, the ignition must be in the on position.
What to do if your parking brake nut comes loose?
Step 1: Put on your safety glasses and grab your flashlight Locate the parking brake cable in the cab of the vehicle. Step 2: Check to see if the cable is broken or frayed. If you have a cable with a bolt attached, check to see if the nut came loose.
Why does the 4 wheel drive light stop flashing?
The transfer case neutral position needs to be selected before you attempt to engage 4WD. The selected position indicator light will flash until the transfer case completes the shift. When the shift is complete, the indicator light for the selected position will stop flashing and remain ON.
How to troubleshoot a parking brake or emergency brake?
Engage the parking brake to the lock the rear tires from moving. Step 1: Put on your safety glasses and grab your flashlight Locate the parking brake lever or pedal.
When does the anti lock brake warning light come on?
There are times when the anti-lock brake warning light may come on on your car’s dashboard when the brakes are in good condition. It may even happen after you have recently had the brakes serviced. If you know your car’s anti-lock brake system is in good condition and the light is still on, there are some steps you can take to reset the light.
Why does the brake warning light keep glowing?
Naturally, the first step is to consider the obvious reasons why that dashboard warning light keeps glowing. The most obvious culprit is the switch located immediately under the parking brake pedal. If this malfunctions, the warning light may glow even if the brake has been released.
Can a brake light be flashed on more than one failure?
Sometimes the first count sequence will be short. However, subsequent flashes will be accurate. If there is more than one failure, only the first recognized code will be retained and flashed. DTCs 6, 9, and 10 will only turn the BRAKE lamp on while the fault exists. These are soft codes faults and can only be read with the Tech 1 scan tool.
How does the brake light on a car work?
The BRAKE light on most vehicles is activated by a simple circuit involving only one or two components. Usually, the brake fluid level sensor and the parking brake are the only two items that can activate the BRAKE light.
