What are the seals on the rear differential?
What are the seals on the rear differential?
There are two seals commonly referred to as rear end seals in the Ford rear differential, the pinion seal and the differential cover seal. Each of these seals will most likely fail at some point in the life of a Ford vehicle, but replacing either or both is not hard.
Can a Ford rear end seal be replaced?
When servicing the differential, the cover seal will be replaced, but there are times when it may leak before or after a service. Place the drop pan under the rear differential and use the socket set to remove the bolts holding the differential cover in place.
How long does it take to replace a differential output seal?
According to most service manuals, the job of replacing the differential output shaft seal may take anywhere from 3 to 5 hours to complete. On some vehicles that have solid rear end housings, the inner seal is referred to as the axle seal, which is typically located on rear wheel drive vehicles and inside the rear hub of the vehicle.
How to replace rear main seal without removing the engine?
Sometimes the seal is stuck into the crankshaft. Cautiously, poke the crankshaft to remove the seal. This seal is the rear main seal that you need to take off. Remove it and install the new one. This is how to replace rear main seal without removing engine easily in no time.
How to replace the outer seal on a differential?
Step 3: Preparing the axle for removal: In most cases, you’ll have to remove the axle from the differential in order to replace the differential outer seal. In this step, you’ll follow the instructions listed in your service manual for removing the following components.
How much does it cost to replace rear axle seal?
If this axle is worn you will see an obvious groove in this area. Do not reuse the axle at this point because the new seal and bearing will fail prematurely. These axles are available at the dealer for about $200.00 bucks. Now we are ready to remove the seal.
How do you remove an axle from a differential?
Step 4: Remove the axle: Once all hardware has been removed to permit you to remove the axle from the differential, pull the axle from the differential. In most cases, this does not require a special tool to remove the axle from the vehicle.
When servicing the differential, the cover seal will be replaced, but there are times when it may leak before or after a service. Place the drop pan under the rear differential and use the socket set to remove the bolts holding the differential cover in place.
