Is a valve body included in a transmission rebuild?

A repair is considered anything less than disassembling the transmission and can include anything from replacing a pump or valve body to a simple solenoid or sensor replacement. The shop may have a different opinion about what they included in a rebuilt transmission.

How much does it cost to rebuild a valve body?

When something happens in the valve body – a leak, an electrical fault, or a crack – it’s best to change the whole thing. The valve body assembly will be in the vicinity of $200 to $500, and the labor to replace it will be around $500 or so. Expect around $1,000 to get you back up and running.

What does a bad valve body do?

Delayed Garage Shifts One of the most common symptoms of a failing transmission valve body is a delay in shifting or harsh shifting. Usually called garage shifts, it’s when there is a harsh shift from park to drive or drive to reverse.

How long does it take to change a valve body?

Since replacing a transmission valve body can take anywhere from 2 to 4 hours to finish, you must figure the hourly rate of a mechanic is between $60 to $100. This means the least you will pay for labor is $120 and the most you will pay is $400.

Can a valve body be replaced in a transmission rebuild?

The Valve body can make or break a good transmission rebuild. The valve body can be replaced as needed with used, re manufactured or new parts, but is typically cleaned and reused. The valve body inspection, cleaning, and re-assembly is one of the most critical parts of the entire transmission overhaul procedure.

Which is the best way to rebuild a valve body?

Valve Body Rebuild Tips & Techniques Bore-by-bore tips for removal, installation, options and checks of valve body components. The detailed steps below correlate to the quick guide steps. 1. Replace OE Boost Assembly This kit includes an increased ratio boost assembly and strong pressure regulator valve spring.

How to return a remanufactured sonnax valve body?

Sonnax remanufactured valve bodies are backed by a Limited Lifetime Warranty. Call (856) 848-0908 for remanufactured valve body product support. To begin an online core return, please visit this page.

How do you remove plugs from valve body?

Loctite can be heated to allow removal. To remove plugs once sealed, heat the area until the sealant melts, then air dry. Flat stone the valve body surface and clean well to remove surface imprints. 4. Replace OE End Plugs a. Most plugs require two O-rings and have a tapped hole to allow for easy removal in the future.

Who is the leader in rebuilt valve bodies?

RevMax is the industry leader in both high performance and rebuilt OEM replacement valve bodies. There are a lot of other competitors out there offering rebuild valve bodies and sometimes it may seem hard to differentiate what’s what and why ours may be a little bit more expensive than some, but there are a lot of reasons.

When to replace or rebuild a transmission valve body?

Rebuilding vs. Replacing the Valve Body The valve bodyis a part of all automatic transmissions that acts as the main control centerof the system. When a failing valve body causes symptoms and/or failures like noise during gear shifts, slippage, delays, and difficulty reversing, a driver is left with no choice but to fix or replace the part.

What happens if a revmax valve is off?

Being off by just .001” can cause valves to stick and side load and ultimately lead to complete transmission failure. Each RevMax valve body has a predetermined protocol that is followed for each valve body type. This protocol insures that the customer gets the highest quality product each and every time.