How to set wheel bearings with nut torquing?

Follow this six-step procedure for nut torquing and back off to adjust wheel bearings to meet correct end play specifications. While oscillating the wheel, torque the adjusting nut to 200 lbf-ft to fully seat the bearing components. Back off the adjusting nut one full turn or until it is loose.

How much torque to back off wheel bearings?

While oscillating the wheel, torque the adjusting nut to 200 lbf-ft to fully seat the bearing components. Back off the adjusting nut one full turn or until it is loose. To establish end play, torque the adjusting nut to 50 lbf-ft while rotating the wheel hub assembly. Back off the inner (adjusting) nut the amount indicated in the chart below.

How do you adjust a non driven wheel bearing?

Adjusting non-driven bearings The bearing is adjusted by tightening the hub nut if it is too loose, or loosening the nut if it is too tight. It should be done with the wheel on and raised on an axle stand. Check for bearing wear

What’s the proper way to torque a nut?

On a single-nut system, install a cotter pin. On a double-nut system, install a jam nut and torque it to the proper specification indicated in the chart below. Use a dial indicator to verify end play (free movement) of the tire and wheel assembly along the spindle axis.

What are the torque specs for the wheel bearings?

seal contact surface and hub bore.
(2) Install brake rotor shield to the knuckle.
(3) Install hub bearing and axle shaft assembly or axle shaft into the housing and differential side gears. Avoid damaging the axle shaft oil seals in the axle housing.

How much torque is need on my wheel axle hub nut?

Tighten the axle nut with a socket and torque wrench; torque the axle nut between 15 to 20-ft pounds of torque to preload the axle bearings. Rotate the hub eight to 10 revolutions by hand to fully seat the bearing races. Loosen the axle nut until it is freely loose, then finger-tighten the axle nut.

What are the lug nut torque specs?

The correct torque for installing lug nuts on your 5 X 8 trailer’s 5-lug wheels will depend on the size of the lugs. For a 1/2-inch lug the torque spec ranges from 75- to 85-ft-lbs. For a 9/16-inch lug the torque spec ranges from 135- to 145-ft-lbs.

What is bearing torque?

Bearing Torque. Bearing torque is the moment required to overcome internal friction to start or maintain rotation of one ring while the other is stationary.

How to set wheel bearings with nut torquing?