How to reset the PassLock 3 security system?

How to reset the PassLock 3 security system?

Turn the key to ON but do not start the engine. The SECURITY light will turn on and stay on. 3. Wait 10 minutes or until the SECURITY light to turn off. 4. Turn the key to OFF for 5 seconds. 5. Turn the key to ON but do not start the engine. The SECURITY light will turn on and stay on. 6. Wait 10 minutes or until the SECURITY light to turn off. 7.

How do I reset the PassLock on my car?

1. Insert the master key with the black head into the ignition lock cylinder 2. Turn the key to ON but do not start the engine. The SECURITY light will turn on and stay on. 3. Wait 10 minutes or until the SECURITY light to turn off. 4. Turn the key to OFF for 5 seconds. 5. Turn the key to ON but do not start the engine.

How do I Turn Off the PassLock security light?

1. Turn the key to ON and attempt to start the engine and release the key to the ON position. 2. The SECURITY light will illuminate. Wait 10 minutes until it turns off. 3. Turn the key to OFF for 10 seconds. 4. Turn the key to ON and attempt to start the engine. If it starts and run, the system has reset.

What happens when the PassLock module fails to work?

THIS COMPONENT’S JOB IS TO TELL THE ELECTRONIC ENGINE CONTROL MODULE (ECM) THAT THE CORRECT KEY IS BEING USED TO START THE VEHICLE. WHEN THIS PART FAILS, YOU’LL HAVE SEVERAL COMMON SYMPTOMS. THE MOST OBVIOUS BEING THAT THE CAR WILL CRANK BUT NOT START.

How do I Reset my PassLock security system?

If it starts and runs normally, the relearn is complete. If you need to program additional keys, 12. Turn the key to OFF. 13. Insert the next key. Turn it to ON within 10 seconds of removing the previously used key. 14. Wait for the SECURITY light to turn off. That may happen quickly.

1. Turn the key to ON and attempt to start the engine and release the key to the ON position. 2. The SECURITY light will illuminate. Wait 10 minutes until it turns off. 3. Turn the key to OFF for 10 seconds. 4. Turn the key to ON and attempt to start the engine. If it starts and run, the system has reset.

How to reset PassLock reset system on Chevy?

1. Turn the key to ON and attempt to start the engine and release the key to the ON position. 2. The SECURITY light will illuminate. Wait 10 minutes until it turns off. 3. Turn the key to OFF for 10 seconds. 4. Turn the key to ON and attempt to start the engine.

THIS COMPONENT’S JOB IS TO TELL THE ELECTRONIC ENGINE CONTROL MODULE (ECM) THAT THE CORRECT KEY IS BEING USED TO START THE VEHICLE. WHEN THIS PART FAILS, YOU’LL HAVE SEVERAL COMMON SYMPTOMS. THE MOST OBVIOUS BEING THAT THE CAR WILL CRANK BUT NOT START.