How to reset dodge durango sunroof?
How to reset dodge durango sunroof?
To reset the sunroof, follow these steps:
- Set the ignition to the ACC ON/RUN position.
- Ensure that the sunroof is in the Fully Closed position.
- Push and hold the Close switch.
- Release the Close switch, then push and hold the Close switch again within 5 seconds to begin the teaching process.
How do you open a sunroof on a Dodge Durango?
To open the sunroof, push and hold the switch rearward. Sunroof will move rearward and automatically stop at full open position. Any release of the switch will stop the movement. The sunroof and sunshade will remain in a partially opened condition until the sunroof switch is pushed again.
What to do if the sunroof does not work?
NOTE: If at any point during the following procedure the sunroof does not respond as expected, restart the procedure at Step 1. 1) Depress and hold the CLOSE push button of the sunroof switch until the sliding glass panel is fully closed. 2) Continue to hold the CLOSE push button of the sunroof switch.
What happens when you close the sunroof on a car?
When holding down the close button, the sunroof should cycle through the open, closed and vent positions on its own. Once the sunroof stops moving the calibration is complete. If you are still having issues, you could possibly have a sensor that has died.
Is there a problem with the sun roof calibration?
Once the sunroof stops moving the calibration is complete. If you are still having issues, you could possibly have a sensor that has died. When I close the sunroof from the Vent positions it seems to be higher along the rear edges than when I close the sunroof from any Open position.
How to calibrate a Dodge Challenger sun roof?
This procedure has worked for JGC and Charger/300/Challenger/Magnum owners. Its for when the sunroof is closing too high or low. Steps 1-6 are for using a Starscan thus starting with #7. 7. Place the ignition switch in RUN position. 8. Close all of the doors. 9. Press and release the vent switch (sunroof should move to vent position). 10.