How to replace ABS wheel sensor in Chevrolet Silverado?
How to replace ABS wheel sensor in Chevrolet Silverado?
All versions of the Silverado have had ABS since its debut in 1999. Raise and support the vehicle. Remove the tire and wheel with a socket wrench. Disconnect the brake rotor with a socket wrench and remove the wheel speed sensor mounting clips from the frame, knuckle and upper control arm.
Why do I need to replace my ABS sensor?
The most common reason for replacing the ABS wheel sensor is metallic debris such as brake dust clogging the sensor. Determine which ABS wheel sensor your Chevy Cobalt will need. You’ll want to be sure the new wheel sensor is compatible with your make and model of Cobalt.
Where is the ABS speed sensor on a truck?
Some older vehicles, trucks with solid axles in particular, will have them mounted on the rear differential. The ABS speed sensor is just a magnetic sensor that induces a voltage as the tone ring slots or ridges pass through the magnetic field of the sensor.
What to use to clean ABS speed sensor?
Step 1: Clean the sensor mounting hole. Before installing the sensor, be sure to use some sandpaper and brake cleaner to clean the sensor mounting hole. Step 2: Clean the tone ring of all fine metal. The ridges on the tone ring will often gather fine metal that is present in dirt.
How do you install an ABS speed sensor?
Before installing the sensor, be sure to use some sandpaper and brake cleaner to clean the sensor mounting hole. Step 2: Clean the tone ring of all fine metal. The ridges on the tone ring will often gather fine metal that is present in dirt. Be sure to remove all this fine metal. Step 1: Prepare to install the sensor.
Where is the ABS controller located on a car?
ABS Brake Control Module Replacement The ABS controller is used to monitor the wheel rotation speed and can go out as electronics sometimes do. This computer module is located on top of the pump motor and is attached by four or five mounting bolts.
How to replace an automotive ABS brake module?
Release the electrical connectors from the unit by pushing the safety clips using a small screwdriver. One connector will be for the main power and ground for the unit, (large wires) while the opposite connector will be sensor inputs and data bus wiring to the main PCM computer which controls when the warning light comes on.
How to replace ambient light sensor 14-19 Chevy Silverado?
If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer. 1A Auto offers high-quality parts online with fast and free shipping and thousands of how-to videos.
