How to program a Ford Edge smart key fob?
How to program a Ford Edge smart key fob?
1. Place the new unprogrammed smart key in the pocket inside of the center console. 2. Press the driver or passenger power door unlock control three times. 3. Press and release the brake pedal one time. 4. Press the driver or passenger power door lock control three times. 5. Press and release the brake pedal one time.
How to lock and unlock a Ford Edge?
1 Lock your vehicle with the keyless entry keypad after all doors are closed. 2 Press the lock button on another intelligent access key. 3 Touch the locking area on the handle with another intelligent access key in your hand. 4 25 seconds elapse
How do you reset the remote key fob on a Ford?
On the seventh cycle, leave the key in the run position. The door locks should all cycle now, as if you pushed the lock and unlock button. Once this occurs, the lock system is in program mode. Push either the lock or unlock button on the first fob you wish to program. The locks should respond to that command.
How does intelligent access work on a Ford Edge?
Intelligent access at the driver door unlocks all doors when you have disabled two-stage unlocking. Press the button to lock all the doors. The turn signals will illuminate. Press the button again within three seconds to confirm that all the doors are closed.
How do I unlock my Ford Edge front door?
Pull a front exterior door handle. The door will unlock and can be opened. Press and hold the door handle lock sensor to lock your vehicle. To avoid unlocking the door inadvertently, be sure to only touch the lock sensor and not other areas of the door handle.
Where is the intelligent access key on a Ford Edge?
The intelligent access key must be within 3 feet (1 meter) of your vehicle. Pull a front exterior door handle. The door will unlock and can be opened. Press and hold the door handle lock sensor to lock your vehicle. To avoid unlocking the door inadvertently, be sure to only touch the lock sensor and not other areas of the door handle.
What does disabling two stage unlocking do on Ford Edge?
Disabling two-stage unlocking allows all vehicle doors to unlock with one press of the button. The turn signals will flash twice to indicate the unlocking mode was changed. The unlocking mode applies to the remote control, keyless entry keypad and intelligent access.
How to turn off courtesy lamps on Ford Edge?
The lamps turn off if all the doors remain closed and: • you press the START/STOP button (intelligent access key only). If you leave the courtesy lamps, dome lamps or headlamps on, the battery saver shuts them off 10 minutes after you switch the ignition off.
