How to install a lower strut on a car?
How to install a lower strut on a car?
TWO LOWER BOLTS STYLE: • (Fig. 4) Remove and save lower mounting nuts (G) and bolts (H). Separate lower strut mount from steering knuckle. • (Fig. 1) Remove and save the bearing plate upper mounting nuts (A). (P-Pack included with new nuts.) • Remove the strut assembly from vehicle (Fig. 5, 6 & 7).
What’s the proper way to tighten a strut nut?
The proper way to tighten top strut nuts: During final assembly of the front struts, screw on the top nut enough to engage the threads to where one or two threads are showing. This is just enough to keep the assembly together as you gather the proper tools.
How do you install spindle to strut assembly?
Push or tap spindle assembly onto strut and remove screwdriver from pinch joint opening. Install spindle-to-strut assembly pinch bolt into spindle and through strut (Fig. 3). Torque bolt (E) to the value shown in the original equipment service manual. • Obtain replacement bolts if threads are bent or damaged. TWO LOWER BOLTS STYLE:
How to install a strut on a steering knuckle?
Separate lower strut mount from steering knuckle. • (Fig. 1) Remove and save the bearing plate upper mounting nuts (A). (P-Pack included with new nuts.) • Remove the strut assembly from vehicle (Fig. 5, 6 & 7). CAUTION: SPRING IS UNDER HIGH COMPRESSION LOAD WHEN INSTALLED.
What’s the best way to replace struts on a car?
Raise the vehicle and support it with jack stands. Start by soaking the strut flange nuts and bolts with rust penetrant. Then pop the hood and spray the strut-tower mounting nuts. Spin two lug nuts onto the studs and tighten to secure the rotor to the hub. While they’re soaking, mount the angle gauge to the top of the rotor and note the angle.
What happens if you remove the center nut on a strut?
Do not remove the center nut or the strut will come apart and it is under high spring tension. Since you’ve removed the bolts from the steering knuckle, the strut might fall loose after you remove these bolts. It might help to have a partner holding onto the strut assembly while you loosen these bolts.
Where are the strut bolts located on a car?
Once the strut bolts are out the strut and steering knuckle are separated. Open the hood and locate the strut towers to remove the bolts. Usually they are located at the midpoint of the inside fender well and look like cylinders. They are most likely held in by three small bolts. Remove the strut tower bolts.
Do you need a compressor to change struts?
It’s recommended that the beginner forego attempts to compress the spring on the old strut using a spring compressor or spring clamps. This method is used to save money by salvaging the old spring and installing it on the new strut, but if you don’t have your own strut compressor, it will run you $700.
How to remove rusted rusted stuck lower control arm bolts?
You want more loosen, less tighten. spray in between. IF THIS IS WORKING THEN SKIP HEAT, IF NO LUCK then hammer spray, impact heat. do this a few times until bolt starts moving. PATIENCE IS KEY. 9)Thats it. It will backout. If you break the bolt using this method, the bolt was too far gone, and there was nothing
