How to adjust inlet valve on Cat 3406?

How to adjust inlet valve on Cat 3406?

Place the appropriate feeler gauge (5) between the inlet rocker arm and the inlet valve bridge. Turn the inlet adjustment screw (4) while the valve adjustment locknut (3) is being held from turning. Adjust the valve lash until the correct specification is achieved.

How to adjust the exhaust valve on a 3406E?

Make an adjustment to the valve lash on the exhaust valves for cylinders 1, 3, and 5. Loosen the valve adjustment locknut (1) . Place the appropriate feeler gauge (5) between the exhaust rocker arm and the exhaust valve bridge. Turn the exhaust adjustment screw (2) while the valve adjustment locknut (1) is being held from turning.

Is there a Caterpillar 3406 engine service manual?

3406 Diesel Engine S/n 70V1 & Up THIS IS A MANUAL PRODUCED BYJENSALES INC. WITHOUT THE AUTHORIZATION OF CATERPILLAR OR IT’S SUCCESSORS. CATERPILLAR AND IT’S SUCCESSORS ARE NOT RESPONSIBLE FOR THE QUALITY OR ACCURACY OF THIS MANUAL.

Where is the feeler gauge on a 3406E?

Place the appropriate feeler gauge (5) between the inlet rocker arm and the inlet valve bridge. Turn the inlet adjustment screw (4) while the valve adjustment locknut (3) is being held from turning. Adjust the valve lash until the correct specification is achieved. Refer to Table 6.

How to adjust valves on a cat 3406?

Remove the top center bolt, and turn the flywheel by 360 degrees in the direction of the engine’s rotation. This will position the No. 6 piston at the top center on the compression stroke. Install the top center bolt in the flywheel. Make an adjustment to the valve lash on the inlet valves 3, 5, and 6. Loosen the valve adjustment locknut (3) .

How to adjust the inlet valve on a 3406E?

Loosen the valve adjustment locknut (3) . Place the appropriate feeler gauge (5) between the inlet rocker arm and the inlet valve bridge. Turn the inlet adjustment screw (4) while the valve adjustment locknut (3) is being held from turning. Adjust the valve lash until the correct specification is achieved. Refer to Table 6.

Do you have to have a cat gauge on a 3406E?

The 3406E and C15 up to the ACERT do not have adjustable bridges. You set the valve lash in the same sequence as any other 3406….although you have to have a Cat gauge to set the injector height. Also, a good rule of thumb is every year or 100K miles on the overhead.

How many BHP does caterpillar g3406 gas compression engine have?

Ratings: 160-242 bkW (215-325 bhp) @ 1800 rpm are NSPS site compliant capable with customer-provided air-fuel ratio control and aftertreatment or available for non-regulated areas. Every engine is full-load tested to ensure proper engine performance.