How much is a new transmission for a Hummer H2?
How much is a new transmission for a Hummer H2?
A Hummer transmission repair or rebuild can vary significantly in cost, with the average transmission replacement cost starting at about $1,800 and costing as much as $3,400.
What kind of engine does a Hummer H2 have?
It’s powered by a standard GM Vortec 6000 6.0-liter V8 producing 325 horsepower at 5200 rpm and 385 lb.-ft. of torque at 3600 rpm. The engine is mated to a heavy-duty 4L65-E four-speed automatic transmission, capable of out-muscling and out-torquing H2’s premium off-road competitors.
How does the transfer case work on a Hummer H2?
The transfer case controls provide five mode selections, four of which can be accessed by dash-mounted button selectors. The fifth mode, neutral, is available by simultaneously pressing two of the button selectors.
What’s the Tow Haul mode on a Hummer?
The “tow-haul” mode switch is available in either of these driving modes. This allows for a different shift progression of the transmission more suitable to trailering operation. However, off-road operation requires a slower, more controlled throttle response.
What is the rear differential lock on a Hummer H2?
4) An Eaton electronic rear differential lock or “4 LO Locked + Rear Diff Locked,” available only when the transfer case is in Low Lock position. It permits locking up the rear differential for optimum slow-speed capability in climbing over large rocks or up long, steep grades.
Where is the OnStar module located in a 2005 Hummer H2?
The cellular modem connects the OnStar(R) system to the cellular carrier’s communication system by interacting with the national cellular infrastructure. The module sends and receives all cellular communications over the cellular antenna and cellular antenna coax. Ask Your Own GM Question
What is the vcim in a Hummer H2?
This system also interfaces with the factory installed vehicle audio system. The vehicle communication interface module (VCIM) is a 3-watt cellular device that allows the user to communicate data and voice signals over the National Cellular Network.
How is the ignition state of a Hummer determined?
Ignition state is determined by the VCIM through class 2 messaging. The module also has the capability of commanding the horn, door lock/unlock, and operating the exterior lamps using the class 2 serial data circuit.
