How much does it cost to replace clutch on Mazda 323?

I had a dealer quote me $1,200 to replace the clutch in my 323 (not that it actually needed doing, but that’s a different story). Given the ludicrous markups the dealers operate with, you should be able to get it done by a specialist brake/clutch joint for closer to $600.

How to remove manual clutch unit from Mazda 3?

1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Remove the aerodynamic under cover No.2 and the splash shield as a single unit.. 4. Drain the manual transaxle oil.. 5. Disconnect and/or remove the following parts in the engine compartment.

How to take off the rear drive shaft on a Mazda3?

-as well taking off the rear mount is easy if one unbolts the three bolts holding it to the tranny and then the one bolt holding it to the car. then just slide away. -the passenger side drive shaft has a “carry” that has three bolts in it that you have to loosen in order to remove it.

Where to install the SST on a Mazda 3?

Install the SST (49 L017 5A0) facing outward. Install the SST (49 L017 5A0) so that it does not interfere with parts such as the fuel pipe. If the SST (49 L017 5A0) interferes, parts such as the fuel pipe could be damaged.

How to remove clutch unit from Mazda 6?

Loosen each bolt one turn at a time in a crisscross pattern until spring tension is released. 3. Remove the clutch cover and disc. 1. Hold the flywheel using the SST. 2. Remove the bolts evenly and gradually in a crisscross pattern. 3. Remove the flywheel. 1. Install the flywheel to the crankshaft. 2.

Do you know how to adjust clutch pedal play?

An error occurred while retrieving sharing information. Please try again later. Hey! Become A Member | Nthefastlane

How much does it cost to replace clutch on Mazda 323?