How much does it cost to replace a water pump on a Toyota Tacoma?
How much does it cost to replace a water pump on a Toyota Tacoma?
The average cost for a Toyota Tacoma water pump replacement is between $388 and $445. Labor costs are estimated between $219 and $276 while parts are priced at $169. This range is based on the number and age of Toyota Tacoma’s on the road.
How long does Tacoma water pump last?
Water pumps are designed to last at least 100,000 miles, however, if your water pump fails, you should replace it with a high-quality original-equipment level unit. Less expensive replacement pumps are available, but they might only have a service life of 30,000 miles.
How to replace the water pump in a Toyota Tacoma?
Loosen and remove the retaining bolts to the water pump and remove the water pump. Clean the gasket mounting surfaces and install a new gasket to the water pump before installing the water pump.
Can you change timing belt on Toyota Tacoma?
In this video we change my timing belt and water pump in my 2002 Toyota Tacoma. This engine is the 5vz-fe 3.4L V6. Note check your cam seals and other seals that may need to be changed. Also if you know how to loosen the tensioner you can change them if they are bad. SST can be made or bought. Here is the thread on the topic:
When to replace timing belt and water pump?
As a rule of thumb, it is best practice to replace the timing belt and water pump together every 60k miles. Part 1 is only needed if you are looking to replace only the water pump. Since the timing cover is off and there is easy access, consider replacing both idlers, tensioner, accessory belts, thermostat and hose.
What to do before installing a water pump?
Clean the gasket mounting surfaces and install a new gasket to the water pump before installing the water pump. Tighten all the short bolts to 80 inch pounds and the long bolts to 17 foot pounds. Install the belt tensioner assembly then continue installing the rest of the components in reverse order.
Loosen and remove the retaining bolts to the water pump and remove the water pump. Clean the gasket mounting surfaces and install a new gasket to the water pump before installing the water pump.
In this video we change my timing belt and water pump in my 2002 Toyota Tacoma. This engine is the 5vz-fe 3.4L V6. Note check your cam seals and other seals that may need to be changed. Also if you know how to loosen the tensioner you can change them if they are bad. SST can be made or bought. Here is the thread on the topic:
Clean the gasket mounting surfaces and install a new gasket to the water pump before installing the water pump. Tighten all the short bolts to 80 inch pounds and the long bolts to 17 foot pounds. Install the belt tensioner assembly then continue installing the rest of the components in reverse order.
What happens if you drain the radiator in a Toyota Tacoma?
Disconnecting the negative battery cable may reset the on-board computer system or parts of the computer system, so be aware that you may have to reset certain settings. Never attempt to drain the radiator when the engine to your Toyota Tacoma is hot. The steam and the hot coolant within the radiator can cause serious burns.
