How does no bus work on a Dodge Durango?

First the airbag then abs light turn on with sound signal,then speedometer stops working, then the dash mileage counter starts blinking, then the rpm gauge stops working, then the dash mileage counter shows No Bus message, then follows the low fuel light with sound signal.

What makes the gauges stop working on a Dodge Durango?

Can also make the gauges stop working by prying up and down on the dashboard and pressing on the lower section of the instrument cluster 😐 Bad electrical connection. Not that hard to get to cluster once plastic bezel pops off.

Why does my cruise control stop working on my Dodge Durango?

Cruise control stops working too but 4WD light works and the rest of the lights work. Car still runs, I can turn it off and on without problems, even the ABS works. Then suddenly starts working again, it comes it goes away. Couple times it seems to me that it occurred driving over some road damage, also restarted working is similar situation.

What kind of truck has no bus gauges?

I have a 2000 ram 1500 2X with the 5.9 automatic, however I believe that this is applies to all gen2 trucks regardless of drivetrain or engine type. My Story… See the end to get straight to my find. I’ve had my gauges go out with the “no bus’ message in the odometer window three times now!

Is there no bus, no gauges possible solution?

I’d like to offer my solution to the frustrating “no bus and no gauges” problem that I see is pretty common. I have a 2000 ram 1500 2X with the 5.9 automatic, however I believe that this is applies to all gen2 trucks regardless of drivetrain or engine type.

How long does it take for no bus gauges to work?

After 15 minutes and all the dash panels have been removed for the second time (why didn’t I off load this the first time) it starts working again. But, What did I do??

Why is my no bus odometer not working?

This ‘bus’ is the 2 wire communication network that all the computers share information on. Your instrument cluster isn’t gettin any info over the bus that’s why you get the ‘no bus’ message and none of your gauges work. This can be caused by any shorted module or broken bus wire. A few PCM sensors can cause this problem too.

How do you get the bus odometer on a Dodge Ram?

Then turn the key on, and from left to right,plug them in one at a time. After their all plugged in,turn the key off. Turn the key back on, and now slowly apply the throttle pedal to wide open and hold it for 3 seconds and then cycle the pedal 2 to 3 times. Your giving the computer the range of the TPS. Now turn off the key again, and now restart.

Why does my 99 Durango have no bus code?

I was thinking a cold solder joint to the coil circuit as it had no spark during the no run condition. I have a 99 Durango 5.2l 4×4 with the Federal Emission PCM and have also had the NO BUS code in the odometer. Mine stalled while driving also and never started again ( to this day it still hasn’t started!)

Is the Dodge Durango 99 PCM a good car?

It’s a 99 PCM with security, Cali emissions, 4wd and a 5.9L. Anyone have one I can borrow for testing purposes? I don’t think this PCM is bad, just trying other avenues. Need some input. Thanks! 99 PCMs tend to be more heat sensitive as they age. Try getting more air directly on it to keep it cooler.

Where is the powertrain control module located on a Dodge Durango?

The powertrain control module (PCM) in your Dodge Durango is located on the right (passenger side) of the engine compartment.

How do you reset the PCM on a Dodge Durango?

Another way to reset the PCM is to scan and clear any diagnostic trouble codes that have triggered the MIL light. You will need a scan tool or code reader/eraser to perform this; they’re not always readily available for everyone.

What was the ground wire on my Dodge Durango?

We took the engine apart in my dodge durango 2001 4.7 and now i cannot remember what the ground wire was attached to.

What kind of electrical system does a Dodge Durango use?

All them items are controlled by the Front Control Module. Has your mechanic checked for codes. The 2004 and up Durangos use a CAN (Controller Access Network) Bus based system. A traditional OBDII scanner will not work. It has to be CAN capable. If your mechanic does not have one, then you need to look else where.

What was the problem with my Dodge Durango?

My 2003 Durango was perfect until yesterday… the a/c went out not the fan just the cool… the ABS light, emission system light, the brake light and the air bag light all came on together. The lights went out for a little while then the a/c worked but then all the above mentioned lights came back on and no a/c!!!!

We took the engine apart in my dodge durango 2001 4.7 and now i cannot remember what the ground wire was attached to.

How did my Durango get hit by lightning?

When all of a sudden out of the blue, my 2004 Durango was hit by lightning. Apparently, the lightning hit the radio antenna (melted to about 3″) then proceed to effect everything do with electric. But, it remained running. Smoke was pouring out of the dash (thought we were on fire). Pulled over, but not turning off the ignition to check for fire.

What causes the digital dash to stop working?

When this is defective, your digital dash may not entirely stop working. However, your gauges will read extremely high/low, act up, or become erratic. Even jumpstarting your vehicle or switching out the battery can cause an electrical spike that can lead to, say, a speedometer going berserk. 7. Wiring Problems

Is there a way to fix no bus no gauges?

No Way Not three times with it working fine for months in between. Cut to the chase. The Connector to the PCM wiring harness at the PDC was loose! Its the one that has a bolt in the middle of a square white connector. As I started to unscrewed it I noticed that the bolt was not tight. Ah ha!

Why does my car’s instrument cluster stop working?

Sensors in the vehicle generate signals that send to the car’s computer. The computer converts them into something that can be read by the instrument cluster. If one doesn’t work, such as the speedometer, how can you tell if it’s a problem with the entire instrument cluster or something else?

What to do if your dash light does not work?

#Test the dashboard light bulbs. If the fuses are working properly, check for a blown bulb in the dashboard. Following the manufacturer’s instructions, disconnect the battery while working on the dash, remove the faceplate covering your vehicle’s dashboard gauge panel. Remove the screws holding the plate on. Carefully remove the faceplate.

Where can I find the time of departure for the DASH bus?

All DASH routes feature real-time departure time information. Find out the exact time of every DASH departure at ladotbus.com PDFs require Acrobat Reader to view.

After 15 minutes and all the dash panels have been removed for the second time (why didn’t I off load this the first time) it starts working again. But, What did I do??

Where is DASH bus service in Los Angeles?

Transit Menu. DASH provides frequent, inexpensive and convenient bus service in downtown Los Angeles and in 27 neighborhoods all across the City of Los Angeles.

How does the PCM work on a Dodge Durango?

The components in the engine, transmission, drivetrain and other areas send information to the PCM. If the PCM detects an issue with a component, it triggers the malfunction indicator light to illuminate on the dashboard of the Durango.

How does no bus work on a Dodge Durango?