How do you secure a PassLock sensor on a car?
How do you secure a PassLock sensor on a car?
Push the stripped end of the black wire into one of the empty holes of the terminal block of your Dummy Passlock Sensor. (see photo above) Tighten the screw to secure it in place. Push the stripped end of the yellow wire into the other terminal of your Dummy Passlock Sensor (see photo) and tighten the screw to secure it in place.
Where is the ignition switch on a GM PassLock?
Pull the radio out of it’s cavity. Disconnect the wiring connector and the antenna wire, and set the radio aside. On the left side of the radio cavity, there will be an opening, through which you will be able to see the Ignition Switch.
What do you mean by wire harness connector?
What is a wire harness connector? A wiring harness is an organized set of wires, terminals and connectors that run throughout the entire vehicle and relay information and electric power playing a critical role in connecting a variety of components.
What to do if your PassLock light does not turn on?
Insert the Key into the ignition switch and try to start the car. It should start, and then stall, with the “SECURITY” light flashing. (In rare cases, the car may keep running and the security light will not illuminate, but that only happens if you are very lucky.)
What kind of wire is in a PassLock?
There is a BLACK (Thin) wire in this connector, called “Bulb Test”, which shows Ground with ignition in the Off position, OPEN in the “Run” position, and GROUND in the “Crank” position. 4: Turn the ignition switch to the “Run” position. Do not crank the car. 5: Cut the Thin Yellow wire and strip both ends.
What kind of PassLock system do I Need?
There are 2 types of Passlock-II systems. To determine which system you have, follow these instructions; 1: Locate two wires, which are THIN and are in the main ignition harness.. Orange/Black (or Black) and Yellow. 2: Cut the Yellow wire, and strip back some of the insulation from the Orange/Black (Or Black) wires.
Push the stripped end of the black wire into one of the empty holes of the terminal block of your Dummy Passlock Sensor. (see photo above) Tighten the screw to secure it in place. Push the stripped end of the yellow wire into the other terminal of your Dummy Passlock Sensor (see photo) and tighten the screw to secure it in place.
Where are the black wires on a GM PassLock?
These are THIN wires. 3: Locate the Black 6 position connector on the LEFT side of the steering column, right above the ignition switch position. There is a BLACK (Thin) wire in this connector, called “Bulb Test”, which shows Ground with ignition in the Off position, OPEN in the “Run” position, and GROUND in the “Crank” position.
