How do you reset the oil life on a 2008 Yukon?

GMC Yukon Change Engine Oil Light Reset Procedures:

Turn ignition switch to ON position with engine off.
Fully depress and release the accelerator pedal 3 times within 5 seconds of turning key.
Change Oil lamp will flash for 2-10 seconds while it resets.
Once it stops flashing, the maintenance light reset is complete.

Why does my dash say service 4 wheel drive?

Service 4 wheel drive in dash indicator comes on and lights go out on the transfer case switch nob. If I turn off the engine and wait for 10 min. then start truck everything is ok. and I can turn nob to whatever location I want and it will shift.

What is the GM service 4 wheel drive message?

GM has issued a service bulletin # 09-04-21-001 to address a Service 4 Wheel Drive Message condition on the vehicles listed below. In addition to the Service 4 Wheel Drive Message, you may also have a C0387 or a C0569 trouble code stored.

Why does my GMC Sierra 1500 say service 4WD?

Having similar issues as above, had to drive the truck in 4wd high for a short period of time without the rear drive shaft, heard a clunk and the service 4wd message came on, the front drive shaft quit which left me stranded.

What happens when service 4 wheel drive trouble codes are stored?

When the trouble codes are stored and the Service 4 Wheel Drive Message is displayed, the transfer case is inoperative for the rest of that particular key cycle. It will test again and reset the message on the next key cycle if the problem hasn’t been fixed. The codes may be stored with or without you requesting a transfer case shift.

What does the 4WD service light mean on a Chevy Suburban?

While driving down the road, transfer kicks out of 2 wheel high and goes into neutral. the only way to get the vehicle to move is to put into auto 4wd. 4WD Service light came on intermittently. 4WD/2WD indicator lights would indicate Neutral or 4WD-L and the engine would bog down until it shifted out of Low.

When did Chevy Suburban Service traction control issue occur?

The topic originally came up in the Chevrolet Forum way back in 2011. And it appears that a lot of folks had encountered the same issue, yet a solution remained elusive. Most of the time, it happens exclusively on the 2007 model year Suburban.

How can I Stop my Suburban 1500 from going 4WD?

Only way to stop it was to stop and restart the motor. Shift into neutral, then push one of the 4WD buttons, then the 2WD button, which you could then hear and feel the transfer case shift back to 2WD. Then it would drive fine until the next time it would do it. About every 50 to 100 miles it does this.