How do you reset the oil change light on a 2011 Dodge Dakota?
How do you reset the oil change light on a 2011 Dodge Dakota?
Reset Dodge Dakota Oil Light After Oil Change for Model Years 2008-2011:
- Turn the key to ON/RUN position with engine off.
- Fully depress and release the accelerator pedal 3 times within 10 seconds.
- Turn the key to the OFF position and then back on to confirm reset was accepted.
How to clear the maintenance required light on Dodge truck?
Make sure that you perform the required maintenance for the truck prior to shutting off the light. When you’re ready to do this, you’ll need a special tool, called a diagnostic reset tool, which is available from Dodge (or a Dodge dealership).
How do you reset the service light on a Honda Accord?
Pull down the fuse panel cover underneath the steering wheel. Plug the electrical connector on the diagnostic reset tool into the pinned connector on the round pin connector in the fuse panel. Turn the ignition key to the “II” position. Wait for the light on the reset tool to go out. When it does, the service light on your dash should also go out.
How do you reset the fuse on a Dodge Ram?
When you’re ready to do this, you’ll need a special tool, called a diagnostic reset tool, which is available from Dodge (or a Dodge dealership). Pull down the fuse panel cover underneath the steering wheel. Plug the electrical connector on the diagnostic reset tool into the pinned connector on the round pin connector in the fuse panel.
Make sure that you perform the required maintenance for the truck prior to shutting off the light. When you’re ready to do this, you’ll need a special tool, called a diagnostic reset tool, which is available from Dodge (or a Dodge dealership).
Pull down the fuse panel cover underneath the steering wheel. Plug the electrical connector on the diagnostic reset tool into the pinned connector on the round pin connector in the fuse panel. Turn the ignition key to the “II” position. Wait for the light on the reset tool to go out. When it does, the service light on your dash should also go out.
When you’re ready to do this, you’ll need a special tool, called a diagnostic reset tool, which is available from Dodge (or a Dodge dealership). Pull down the fuse panel cover underneath the steering wheel. Plug the electrical connector on the diagnostic reset tool into the pinned connector on the round pin connector in the fuse panel.
