How do you reset the computer on a 2004 Dodge Durango?
How do you reset the computer on a 2004 Dodge Durango?
How to Reset the PCM on a Dodge Durango
- Open the hood of the Durango.
- Locate the battery and remove the black-wired negative terminal from the battery.
- Turn the ignition key to the “on/crank” position for 30 seconds, then replace the ignition key to the “off” position.
How do you reset the PCM on a Dodge Durango?
Another way to reset the PCM is to scan and clear any diagnostic trouble codes that have triggered the MIL light. You will need a scan tool or code reader/eraser to perform this; they’re not always readily available for everyone.
How to reset the engine control module ( ECU )?
The 2 most common ways to reset your car computer is by either unplugging the battery or by resetting the fuse related to the engine control module Will disconnecting battery reset ECU? Disconnect the battery and Switch the ignition key to the on position for about 15 minutes should reset the ECU
How do you change the battery in a Durango?
Open the hood of the Durango. Locate the battery and remove the black-wired negative terminal from the battery. Turn the ignition key to the “on/crank” position for 30 seconds, then replace the ignition key to the “off” position. Reconnect the negative battery terminal and close the hood.
How to reset the Check Engine light on a Dodge Ram?
Dodge Ram: How to Reset PCM and Check Engine Light. 1 Step 1 – Remove the PCM fuse. First, park your truck and turn it off. Pull the hood lever under the driver’s side dash, and then pull the safety catch 2 Step 2 – Reset the PCM. 3 Step 3 – Re-install the PCM fuse. 4 Related Discussions.
The 2 most common ways to reset your car computer is by either unplugging the battery or by resetting the fuse related to the engine control module Will disconnecting battery reset ECU? Disconnect the battery and Switch the ignition key to the on position for about 15 minutes should reset the ECU
Another way to reset the PCM is to scan and clear any diagnostic trouble codes that have triggered the MIL light. You will need a scan tool or code reader/eraser to perform this; they’re not always readily available for everyone.
Where is the powertrain control module located on a Dodge Durango?
The powertrain control module (PCM) in your Dodge Durango is located on the right (passenger side) of the engine compartment.
Open the hood of the Durango. Locate the battery and remove the black-wired negative terminal from the battery. Turn the ignition key to the “on/crank” position for 30 seconds, then replace the ignition key to the “off” position. Reconnect the negative battery terminal and close the hood.
