How do you reset an airbag light in a car?

Turn the ignition off a second after the airbag light has turned off. Turn the ignition switch of your car back off for a little longer than three seconds. Repeat steps 1 through 3 twice to make three times total. Turn your ignition switch back on to fully reset the airbag light.

How long does it take for airbag light to turn off?

Repeat steps 1 through 3 twice to make three times total. Turn your ignition switch back on to fully reset the airbag light. Once you start your car, your airbag light should turn on for around seven seconds before finally turning off.

What does it mean when your airbags wont turn off?

You may know that your airbag light won’t turn off, from your car. Your vehicle will tell you with either a flashing or illuminating light on your computer or dashboard display. When the light is on, this means that your airbags are deactivated. This further means that your airbags will not deploy should they need to.

How do you replace an airbag light without a scanner?

Replacement with a new one is one way you can remove the airbag light without a scanner. Next, loosen the steering nuts using a breaker bar. This ensures that you do not remove the steering wheel completely. Pull it back and forth because the steering wheel could be strongly attached to the steering shaft.

How do you turn off an airbag light?

For turning OFF your airbag light you must connect a diagnostic scantool to the data link connector of the car. in order to access the Airbag ECU ( Electronic Control Unit ) and erase all faults memored. In other words reset the Airbag ECU. Then the Airbag light will turns OFF.

How do I get my airbag light to turn off?

Step 1 Turn on the ignition switch with your car key. Wait for the airbag warning light to turn off. Turn the ignition switch of your car back off for a little longer than three seconds. Repeat steps 1 through 3 twice to make three times total. Turn your ignition switch back on to fully reset the airbag light.

Why does the airbag light stay on?

Light stays on and warning for airbag service on reader board. If the airbag light stays on after it completes it’s “check light” process then there is a fault in the air bag system. It could be anything from a bad sensor (there are 3 of them) to a wire that has become unplugged. This problem should be repaired as soon as possible because…