How do you replace a gas crossover tube?
How do you replace a gas crossover tube?
Remove the screw on back of the side control panel cover and carefully pull the cover up. Remove the igniter. You’ll see 2 brackets holding the gas manifold in place. Remove the screws and pull manifold away from the burner tubes. Remove grates and flavorizer bars.
How do you replace an exhaust crossover pipe?
1] Hidden under all that stuff is the old, leaking crossover pipe. We removed the air cleaner and battery to improve access. 2] First, soak all the hardware in penetrating oil, preferably for a few hours. 3] This bolt on the rear manifold proved tough to turn.
How can I replace my Origi NAL crossover pipe?
1. A problematic bracket that supported the middle of the origi-nal crossover pipe has been eliminated. (Ours had already failed at a welded joint.) 2. The flexible metal bellows have been improved by switching from a multipart crimped design to more robust, one-piece swaged bellows.
Is the crossover tube on my Weber grill corroded?
One issue with the grill is that burner tubes #2 and #3 won’t light off of #1. I inspected the burner assembly and found the crossover tube to be completely corroded. I called Weber to inquire about a replacement part and they are sending me a new crossover tube.
Remove the screw on back of the side control panel cover and carefully pull the cover up. Remove the igniter. You’ll see 2 brackets holding the gas manifold in place. Remove the screws and pull manifold away from the burner tubes. Remove grates and flavorizer bars.
When to remove the crossover pipe in a car?
Once the crossover pipe is removed, look closely at the exhaust pipe, (the section of the exhaust system that includes the catalytic converter and muffler) to determine if it also needs to be removed.
How do you remove transmission from cross member?
With the weight of the transmission resting on the jack, remove the transmission mount bolts. Removing the transmission mount bolts (or nuts) allows the transmission to be separated from the cross member. Remove the cross member to frame mounting bolts and then remove the cross member.
How do you remove a torque converter cover?
The cover is normally made of thin metal or aluminum and is held in place by a several 10mm or 12mm bolts. Once cover is removed, using a flashlight or droplight, look inside the bell housing to locate the bolts/nuts holding the torque converter to the flywheel/flex-plate.
