How do you replace a cv shaft on a Chevy Trailblazer?
How do you replace a cv shaft on a Chevy Trailblazer?
Use the tie rod end puller for this. Wedge a flat tip screwdriver between the transaxle/transmission housing and the end of the CV shaft and pry the shaft out of the transmission. Remove the shaft from the transmission and insert the new shaft. Make sure that the ring clip on the new CV shaft is inserted into the transmission.
How do you remove diff from Chevy Trailblazer?
Pull your axles. Unbolt the diff and shove it to the side against the frame, I used a motorcycle strap to hold it there. Unbolt the pan and pull it, then undo the motorcycle strap and out comes the diff. When dropping oil pan can I leave the diff attached to oil pan ?
Where is the pinch bolt on a Chevy Trailblazer?
Remove the steering knuckle pinch bolt at the base of the strut. Separate the lower control arm from the steering knuckle by tapping on the knuckle with a hammer.
Where is the front jack on a Chevy Trailblazer?
Place the jack underneath the Trailblazer’s front jack point and jack up on it. The front jack point is located near the radiator and is an extension of the frame. Finish removing the lug nuts and pull the wheel off. Loosen the spindle nut using a spindle-nut socket and your impact wrench.
Use the tie rod end puller for this. Wedge a flat tip screwdriver between the transaxle/transmission housing and the end of the CV shaft and pry the shaft out of the transmission. Remove the shaft from the transmission and insert the new shaft. Make sure that the ring clip on the new CV shaft is inserted into the transmission.
How to remove CV axle nut from wheel bearing?
Remove CV axle nut (35 mm) Tap end of CV axle to remove from wheel bearing Remove (or cut off) end link Remove upper ball joint from upper control arm Remove nuts from upper strut mount Gently pull down on knuckle to attain room to entirely remove wheel end of CV axle from wheel bearing Remove oilpan skidplate
How to repair a 4wd front axle disconnect?
Lift front of vehicle and properly stabilize Remove passenger front wheel Un-clip wheel sensor wire (3 places) Remove brake line holder from knuckle Remove CV axle nut (35 mm) Tap end of CV axle to remove from wheel bearing Remove (or cut off) end link Remove upper ball joint from upper control arm Remove nuts from upper strut mount
Remove the steering knuckle pinch bolt at the base of the strut. Separate the lower control arm from the steering knuckle by tapping on the knuckle with a hammer.
How much does it cost to replace a CV axle on a trailblazer?
Chevrolet Trailblazer CV Axle / Shaft Assembly Replacement costs $376 on average. What are CV Axles and how do they work? All front wheel drive and all wheel drive cars use CV axles.
How does a cv shaft work on a Chevy Trailblazer?
Like all Chevys, the TrailBlazer uses a CV shaft and axle to transfer the power from the engine to the drive wheels. The CV joint is what allows the shaft to flex so that a bump, pothole, or turning doesn’t snap the CV shaft in half.
How to remove CV axle from 2005 Envoy?
Separate lower ball joint from lower control arm. Pull wheel hub steering knuckle assembly from front axle. Set aside on blocks under wheel well with brake line still attached. Remove right front CV axle using a brass drift and 2 lb mason hammer against tripot housing.
How to remove the front axle disconnect assembly?
Set aside on blocks under wheel well with brake line still attached. Remove right front CV axle using a brass drift and 2 lb mason hammer against tripot housing. Now you have clear access to the front axle disconnect. Disconnect the electric plug from the disconnect assy. Remove the actuator. Remove 4 bolts holding assy to oil pan.
