How do you remove the spare tire from a Ford Ranger?

How do you remove the spare tire from a Ford Ranger?

The lock is located between the rear bumper and the tailgate, Slide the square end of the jack handle through the access slot. Rotate the handle until it engages with the spare tire’s lift cable. Rotate the jack handle with the wheel nut wrench counterclockwise to lower the spare tire to the ground.

How do you get the spare tire off a Ford Ranger without tool?

Removing a spare tire without the factory tool is easy when you follow these steps:

1. Get under the truck.
2. Pull off the guide tube.
3. Pull out the key with pliers.
4. Insert crank into the new hole.
5. Turn the crank counterclockwise to lower the tire.

Where is the spare TYRE on a Ford Ranger?

Fortunately, accessing and removing the spare tire on a Ford Ranger is fairly simple, despite the fact that the tire is located underneath the bed. Tires are subject to extreme conditions, so they must be in good condition to keep you safe on the road.

How do you jack up a Ford Ranger?

How to Lift a Ford Ranger

1. Park on a level, flat surface. Pull the emergency brake, and shift the gears into either reverse or park.
2. Block off the wheel diagonally across from the wheel you intend to lift.
3. Place your car jack at the right lifting points.
4. Turn the jack’s crank and lift the Ranger.

Does the Ford Ranger have a spare wheel?

Tires must be replaced after their tread wears down. Fortunately, accessing and removing the spare tire on a Ford Ranger is fairly simple, despite the fact that the tire is located underneath the bed.

Where is the spare tire on a Ford Ranger?

Fortunately, accessing and removing the spare tire on a Ford Ranger is fairly simple, despite the fact that the tire is located underneath the bed. Put together the Ranger’s two jack handle pieces. Slide one piece onto the end of the second piece until the two pieces snap into place.

How do you put a spare tire on a truck?

Slide one piece onto the end of the second piece until the two pieces snap into place. Slide the slotted end of the handle through the square opening on the side of the truck’s wheel nut wrench until the handle snaps into place. Remove the lock that covers the spare tire access hole, using the lock’s key, if so equipped.

How do you get a spare tire out of a scissor jack?

Rotate the jack handle with the wheel nut wrench counterclockwise to lower the spare tire to the ground. Rotate the tire retainer in the centre of the spare tire in a counterclockwise direction until the retainer separates from the tire, then pull the tire from under the truck.

Fortunately, accessing and removing the spare tire on a Ford Ranger is fairly simple, despite the fact that the tire is located underneath the bed. Put together the Ranger’s two jack handle pieces. Slide one piece onto the end of the second piece until the two pieces snap into place.

Slide one piece onto the end of the second piece until the two pieces snap into place. Slide the slotted end of the handle through the square opening on the side of the truck’s wheel nut wrench until the handle snaps into place. Remove the lock that covers the spare tire access hole, using the lock’s key, if so equipped.

Rotate the jack handle with the wheel nut wrench counterclockwise to lower the spare tire to the ground. Rotate the tire retainer in the centre of the spare tire in a counterclockwise direction until the retainer separates from the tire, then pull the tire from under the truck.