How do you remove the passenger door module?

This method of removal applies to both the driver door module (DDM) and the passenger door module (PDM). The illustration shows the driver door module (DDM). Ignition off Remove the door panel Remove the nut and screw holding the door module Disconnect the connectors Pry up the rear edge of the door module.

How do you remove a car door holder?

Unbolt the door holder from the body of the car. Note: In some vehicles the door holder is an integrated piece on one or both of the door hinges. If you find this is the case, skip to the next step. Unbolt the hinges. Unbolt the hinges from the door. Remove the door. With the bolts removed, the door should basically fall away from the car body.

When to replace the driver door module ( DDM )?

Replacing the driver door module (DDM) and passenger door module (PDM) Preparations Caution!€New software can only be ordered after the control module has been installed in the car. VADIS reads off the new control module identity which is required to order the correct software.

How can I adjust the fit of my car door?

Adjust door fit: Hinge bolts are the only way to adjust the door fit without serious body work. Loosen the door hinge bolts slightly, just enough to shift the door, try to move the door in the hinge bolt holes. (Not every car will be able to move the door within the bolt holes.

How to replace the window motor in a 2001 Chevy Silverado?

Lift the Silverado’s door panel upward two inches to clear the lock knob before removing the panel from the door by hand. Raise the window glass by hand until you can secure it to the top of the door with the packing tape. Remove the two bolts holding the faulty window motor to the door and regulator with the socket set.

How do you remove a door from a Jeep Cherokee?

Pull the electrical through. Disconnect the door retainer that holds the door open either by hammering the pin upwards, by unbolting it, or by cutting it off. Unbolt the door from the hinges or in the older Jeep Cherokee’s case, cut the hinges with a sawzall.

Where is the door module located on a car?

This method of installation applies to both the driver door module (DDM) and the passenger door module (PDM). Position the door module in the hole on the door panel.

Why are the door locks on my Suburban not working?

My 1997 2500 Suburban has a different twist. The lock/unlock switch on the driver side arm rest will not activate the door locks. But….. They all function automatically by locking when the truck is started and placed in gear and by unlocking when the truck is shut off. I checked the fuse box and found #13 fuse blown.

Why is the cowl not connecting to the driver side door?

Of course it is also possible that the wiring harness between the driver side door and cowl is corroded and that some of the pins are to corroded or even broken off and do not make contact. Also check that you have good and tight positive and negative battery cable connection to the battery posts.

Why does my driver side door lock not work?

The windows and the locks are on two separate circuits. The only part that these two have in common is the master switch. Of course it is also possible that the wiring harness between the driver side door and cowl is corroded and that some of the pins are to corroded or even broken off and do not make contact.

How do you remove the passenger door module?