How do you remove the front drive shaft on a Ford Explorer?
How do you remove the front drive shaft on a Ford Explorer?
Use a pry bar or screwdriver to hold the rear yoke while You unbolt the front of the driveshaft with an extension and the 8mm socket. Employ a pry bar and hammer to shift the shaft side of the flange and move it away from the transfer case end, freeing the shaft from the yoke.
How do you remove the front drive shaft on a Chevy?
Mark both ends of the shaft. Move to the front of the shaft where it connects to the axle housing. Remove the four retaining bolts from the pinion yoke with a wrench, then lift off the two retaining straps. Pull straight back on the drive shaft, releasing the two U-joint caps from the yoke.
How do you replace the front drive shaft on a Ford Ranger?
Unscrew the nuts, bolts and straps that connect the front drive shaft to the front axle yoke, using a wrench and socket. Slide the drive shaft underneath the front axle while pulling it towards the front of the vehicle. This will separate the splined shaft from the transfer case.
How do you remove a drive shaft from a mower?
Pull straight back on the drive shaft, releasing the two U-joint caps from the yoke. Move to the transfer case end of the drive shaft. Locate the four retaining bolts, remove them with a wrench and pull the shaft off the transfer case. You may need to rotate the drive shaft to get to all the bolts.
Can a front drive shaft be disconnected from a rear drive shaft?
IT also depends on your AWD transfer case, however you cannot disable an axle on a AWD vehicle. If you disconnect drive shaft to the rear axle the car will not move. That is because the center diff cannot transfer 100% of the power to the front drive shaft, so it will move until the viscous coupling loses all ability to resist shear.
Unscrew the nuts, bolts and straps that connect the front drive shaft to the front axle yoke, using a wrench and socket. Slide the drive shaft underneath the front axle while pulling it towards the front of the vehicle. This will separate the splined shaft from the transfer case.
How does a four wheel drive drive shaft work?
In the case of a four wheel drive vehicle, you may find that it actually has two separate drift shafts; one for transmitting power to the front and another to transmit power to the back. Since drive shafts rotate quickly, they’re able to move the rear wheels of your vehicle.
Where does the torque go in a rear wheel drive car?
Most economy cars are front-wheel drive, so the torque would be transmitted to the two front wheels with what’s called a half-shaft. But if you have a rear wheel drive or four wheel drive vehicle, then a long drive shaft (or propeller shaft) is needed to transfer the torque produced by the engine to the two rear wheels.
How much does it cost to replace a front wheel drive shaft?
If you’re just replacing the drive shaft for your front wheels, then it will cost anywhere from $470 to $940. You can expect the parts cost to be anywhere from $320 to $750, while the labor costs are only around $150 to $190.
