How do you remove a lock cylinder from an ignition?
How do you remove a lock cylinder from an ignition?
Using channel lock pliers, twist lock cylinder cap until it separates from lock cylinder. Using a 3/8″ drill bit, drill down center of ignition lock key slot about 1 3/4″ until lock cylinder breaks loose from its base. Remove retainer, washer, and lock cylinder gear from housing.
How can I get the ignition off my car without a key?
Turn on your power drill and use your drill bit to make a hold in the key slot of the ignition cylinder. Be sure to make the hole large enough for you to insert your screwdriver, and drill to the back of the key slot. Insert a straightened out paperclip into the slot just to the left of the key cylinder. This will lock the cylinder from starting.
How to fix ignition lock cylinder on 1994 Ford F150?
Using a 3/8″ drill bit, drill down center of ignition lock key slot about 1 3/4″ until lock cylinder breaks loose from its base. Remove retainer, washer, and lock cylinder gear from housing. Remove metal shavings from lock cylinder bore. Replace housing if damaged. To install, reverse removal procedure. Connect negative battery cable.
How do you replace an ignition tumbler without a key?
Turn the cylinder to the left using the screwdriver, and use the paperclip and the screwdriver to gently pull out the existing cylinder. Push the new cylinder into place and use your ignition key or a screwdriver to turn it into its correct spot.
Using channel lock pliers, twist lock cylinder cap until it separates from lock cylinder. Using a 3/8″ drill bit, drill down center of ignition lock key slot about 1 3/4″ until lock cylinder breaks loose from its base. Remove retainer, washer, and lock cylinder gear from housing.
Turn on your power drill and use your drill bit to make a hold in the key slot of the ignition cylinder. Be sure to make the hole large enough for you to insert your screwdriver, and drill to the back of the key slot. Insert a straightened out paperclip into the slot just to the left of the key cylinder. This will lock the cylinder from starting.
Using a 3/8″ drill bit, drill down center of ignition lock key slot about 1 3/4″ until lock cylinder breaks loose from its base. Remove retainer, washer, and lock cylinder gear from housing. Remove metal shavings from lock cylinder bore. Replace housing if damaged. To install, reverse removal procedure. Connect negative battery cable.
How do you drill out an ignition cylinder?
Using a 1/8″ bit, drill out retaining pin located below lock cylinder on housing. DO NOT drill deeper than 1/2″. Using channel lock pliers, twist lock cylinder cap until it separates from lock cylinder. Using a 3/8″ drill bit, drill down center of ignition lock key slot about 1 3/4″ until lock cylinder breaks loose from its base.
