How do you reassemble a steering column in a Camaro?
How do you reassemble a steering column in a Camaro?
Align the ignition switch actuator rack with the ignition switch actuator assembly while re-installing the steering column housing. The end of the actuator rack should fit in a notch on the actuator assembly. Install the pivot pins by aligning the steering column housing and locking the steering wheel lock shoes.
Where is the ignition switch on a GM tilt steering column?
The ignition switch bolts to the column with a 5/16″ stud-headed screw. Install the screw finger tight at this time, note the slots that allow the ignition switch to be adjusted up or down the column: We’ll adjust the ignition switch later, after the column is fully assembled. Inside the GM Tilt Steering Column Page 16
How do you replace an ignition switch on a car?
Installing a Replacement Squeeze the release pin on the ignition switch so it’s flush with the side. The same release pin that stopped the switch from coming out now needs to be pressed in so you can slide the switch into place inside the ignition module. Slide the ignition switch into its hole.
Where is the lower bearing adapter on a Camaro?
Remove the 11mm bolt connecting the steering shaft to the intermediate steering shaft. Remove the “lower bearing adapter,” which is located at the bottom of the steering column in the engine bay. Remove the clip, bearing cover, and the beige plastic cover using a flat head screwdriver or pry bar.
Where is the ignition cylinder located on a Camaro?
Up until 1969 they were mounted in the dash. You need a paper clip and your ignition key to remove the cylinder from the instrument cluster (1967-1968). From 1969 forward they were installed in the head of the steering column. What year vehicle?
How do you replace a cylinder in a Camaro?
As Jim said, use a paper clip and push into the hole and at the same time, turn the cylinder to ACC and the lock cylinder will unscrew out if its body. Reassemble with the new cylinder and key in reverse without the paper clip, or with the paper clip.
Installing a Replacement Squeeze the release pin on the ignition switch so it’s flush with the side. The same release pin that stopped the switch from coming out now needs to be pressed in so you can slide the switch into place inside the ignition module. Slide the ignition switch into its hole.
Can you use an old key on a Camaro?
You may want to try an old key for 68’s. Sometimes those switches are worn to the point that another key can work. If so, you can use the key with the paper clip to remove the cyl. You may want to try an old key for 68’s. Sometimes those switches are worn to the point that another key can work.
