How do you put rear brake shoes on a car?
How do you put rear brake shoes on a car?
Then, turn the center spring bolt, and remove the shoe from the axle. Press the new shoes onto the brake where they will naturally fit in only one direction. While holding the shoe in place, tighten the spring bolt, then fasten the long springs onto their hooks on each shoe. This will hold the shoes in place.
What’s the best way to install a drum brake?
If that is the case, be sure to liberally spray the drums with brake cleaner to remove any of the film that may be present before installing them. Step 2: Install the drum brake over the brake shoes. Once the drum is clean and ready to install, slip it over the brake shoes and install it onto the hub.
How do you replace the parking brake on a car?
Detach the parking brake lever. Hold the shoe retaining pin from the back and remove the retainer springs. Spread the shoes apart from the top and disengage the shoes from the wheel cylinder pins. Remove both shoes and the self-adjuster as one unit. Lay the old shoes on the ground next to the new ones.
How to install parking brake shoe on Toyota Yaris?
(a) Apply high temperature grease to the surface of the backing plate which is in contact with the shoe. (b) Using needle-nose pliers, install the parking brake cable onto the parking brake shoe lever. (c) Using SST, install the rear brake shoe, pin, shoe hold down spring and shoe hold down spring cup. SST 09718-00010
What’s the best way to replace rear brake shoes?
Step 1: Remove the brake drum. Remove the drum by pulling it straight out towards you. If it does not come off easily, hit the front of it with a hammer to loosen it. Step 2: Inspect the brakes. Before you dig into replacing your brake shoes you’ll want to measure and inspect everything.
How do you change the brakes on a car?
Adjust the brakes using a screwdriver or dedicated brake spoon. Expand the shoes until the drum can just barely be turned by hand. Back off the adjusting screw 12 notches. If the shoes still are dragging, back off the adjusting screw a couple more notches. Step 10: Install the brake drum. Install the brake drum by sliding it onto the hub assembly.
What’s the best way to replace brake Springs?
Align the new brake shoes with the old set on a flat table or bench and start removing brake springs and swapping them to the new shoe set. Try not to get the linings of the new shoe set dirty as this can distort their braking ability. If dirt or grease does get on the linings try to use a small amount of brake cleaner to help remove it.
How are brake shoes and drums used in a car?
A mechanical activation system of the emergency brake uses the same principle of forcing the shoes outward against the drum helping to hold the car in place. Vehicles with rear disc brakes will use a smaller drum brake in the center of the rotor for the emergency brake.
