How do you hook up a trailer brake controller?
How do you hook up a trailer brake controller?
Route the wiring harness out of the junction box through the upper side of the cover. Figure 3. The orange trailer brake controller 6-pin connector has been plugged into the junction box. Zip tie the wiring harness up and away from the floor board, then plug the connector into the back of the controller. Figure 4.
Do you need a trailer brake controller for a Chevy Silverado?
If your trailer has electric trailer brakes, you will benefit by installing a trailer brake controller. This will give you precise control over how much braking power you want from your trailer brakes. This article applies to the Chevrolet Silverado 1500 (1999-2006).
Where is the adapter for the brake controller?
The wires for the brake control adapter and the wires coming out of the brake controller match up color for color. The wires match up: red to red, black to black, white to white, blue to blue. Then plug the adapter, which is now connected to the brake controller, into the plug under the dash.
How to install an electric brake controller on a Dodge Ram?
Step 1 – In the Back: Start in the rear of the vehicle by first installing the 4-Pole trailer connector. Next, find a good place to mount the 7-way or 6-way trailer connector and then connect it to the newly installed 4-Pole. Ground the 7-Way or 6-way connector and run the extra-long wire lead up to the front of the vehicle.
How do you hook up a brake controller to a trailer?
Strip the wires on the brake controller harness if needed (#51515). Then, attach butt connectors. Splice the wires from the vehicle to the brake controller harness, matching the colors as follows: With the wires securely crimped together, you can now plug the brake controller harness into your brake controller unit.
How does trailer brake controller work on Chevy Silverado?
This article applies to the Chevrolet Silverado 1500 (1999-2006). A trailer brake controller displays the voltage level on the wiring traveling from your truck’s brake pedal to the trailer’s electric brakes. The higher this voltage level is, the harder your trailer brakes are being applied.
Where to wire electric brakes on a tandem axle trailer?
It does not matter which wire is used for power or ground because they are not polarized. If the trailer wiring is running down the left side of the trailer, then we splice the left side brake assemblies into the main electric brake power wire coming from the 7-way connector.
Where is the trailer brake harness on a Chevy Silverado?
This will allow you to make the proper connections to the harness located under the dash. Looking under the driver side dash on the left side, you’ll see a wiring harness taped up out of the way. This is the trailer brake harness that you’ll need to pull down.
