How do you clean the EGR valve on a Ford Transit?
How do you clean the EGR valve on a Ford Transit?
Rather than cleaning the EGR valve of their Ford Transit, they simply choose to block it in the closed position. This manipulation will have the outcome of greatly increasing the pollution released by the car, of no longer complying with pollution criteria, of having an engine warning light permanently on and in the end risk fouling the engine.
Can you use EGR delete on Ford 6.0L?
In some cases, yes. Installing an EGR delete on 2006 and up 6.0L trucks WILL result in the check engine light. In fact, it will set the check engine light on all Ford 6.0L’s with software that has been updated since about 2005. This means that an EGR delete will set the CEL on most 6.0L’s on the road today.
Can you delete the Check Engine light on a Ford 6.0L?
Installing an EGR delete on 2006 and up 6.0L trucks WILL result in the check engine light. In fact, it will set the check engine light on all Ford 6.0L’s with software that has been updated since about 2005. This means that an EGR delete will set the CEL on most 6.0L’s on the road today.
Is there an EGR delete for a minibus?
EGR delete is also available for other cars & vans & costs from £100 – Call for advice on 07956 555 666 ( office hours only please ) This picture below is a cleaned EGR from a Mk6 Transit 125ps Jumbo Minibus, we cleaned this out along with the inlet manifold. This is a great job to do if your’e in search of economy on a TDDI engine.
Rather than cleaning the EGR valve of their Ford Transit, they simply choose to block it in the closed position. This manipulation will have the outcome of greatly increasing the pollution released by the car, of no longer complying with pollution criteria, of having an engine warning light permanently on and in the end risk fouling the engine.
When to clear DTCs on Ford Transit?
However, strange thing is that when I monitor EGR valve position with engine running using Forscan, it reports an error of 20-30% between commanded and actual valve position from start-up for about 5 minutes, until the engine is warm (during this period I can clear DTCs and the same P042f code returns).
When does EGR go back to normal Ford Transit?
However, after 5 mins, when the temperature gauge starts to come up, the error between commanded and actual EGR disappears, right down to 0% in steady state, and I can then clear DTCs and the EGR code doesn’t return. I have repeated this a few times, letting engine cool down, and it always behaves the same.
How to reset service interval indicator on Ford Transit?
Ok no problem – The way to reset the system and the light is as follows : MIKE : Turn ignition key to position II. Press brake and accelerator pedals together for 15 seconds. Service interval indicator will flash when reset complete. Release pedals and turn ignition OFF. MIKE :
