How do you check 47RE line pressure?

How do you check 47RE line pressure?

The best way to do a pressure check is to put one gauge on the line pressure port and one on the accumilator, the line pressure will be there once it is in gear, the accumilator pressure won’t be there till it picks up 3rd gear.

How do you check the fluid in a 47RE?

Check the fluid level on the dipstick. The fluid level should be in the “safe zone” on the dipstick after 17 qts. Place the dipstick back into the tube. Inspect the transmission pan for any leaks while the engine is running.

How do I adjust my 47re pressure?

To turn up the line pressure, you need to drop the pan and turn the pressure adjustment allen-head bolt clockwise 1-2 turns. While you’re in there, make sure all the hex head bolts are tight and readjust the low/reverse band.

Where can I find a 47RE transmission troubleshooting chart?

47RE transmission troubleshooting chart. Hey everyone! Enter your ride HERE to be a part of this month’s Ride of the Month Challenge! With all of the automatic transmission troubleshooting questions on this site this information is needed here. This was originally found on DodgeTalk

What should the governor pressure be on a 42-47re?

If a 42-47RE transmission doesn’t shift properly from first through third gears, your first check is alwaysgover- nor pressure. Governor pressure should be zero at a stop, and rise about one PSI per MPH, up to about 40 MPH.

What should the reverse line pressure be on a 47RE?

Reverse will be over 250psi usually. – WOT Is defined as the TV lever being moved fully rearward into the open position. You should see a smooth increase of line pressure to the maximum. This test checks pump output, pressure regulation, and condition of the rear clutch and servo circuit.

Where is the overrunning clutch applied in a 47RE?

The rear clutch is applied in all forward ranges (D, 2, 1). The overrunning clutch is applied in first gear (D, 2 and 1 ranges) only. The rear band is applied in 1 and R range only. The overdrive clutch is applied only in fourth gear.