How do you calibrate a Eaton clutch?
How do you calibrate a Eaton clutch?
Contact Roadranger Call Center 1-800-826-4357 for help. Select the “Calibrate Clutch” button to calibrate new cultch and then Select “Finish” when complete.
What is the standard warranty on an Eaton 3 Series clutch?
The Advantage® Self-Adjust and Easy Pedal Advantage® clutch standard warranties are increased to three years/unlimited miles (from two years/unlimited miles), and the standard warranty periods for EverTough® Self-Adjust and EverTough Manual-Adjust clutches are increased to two years/unlimited miles (from one year/ …
What is an ECA clutch?
The Electronic Clutch Actuator (ECA) is a non-serviceable sealed component that is internally greased during initial assembly. This process is designed to extend the life of the ECA by redistributing the grease within the internal gearing.
How to reinstall an Eaton medium duty clutch?
Note: Mark the proper position of the discs and intermediate plate (for reinstallation). 4. Reinstall the clutch using the original installation instructions for Eaton Solo Medium Duty Clutches or you can reach the nearest Eaton®Roadranger®Sales and Service office by calling 1-800-8 26-HELP (4357) from anywhere in North America 24 hours a day.
How do you replace a Eaton clutch on a flywheel?
If the tab is near the “REPLACE” position, the clutch should be replaced. 1. Locate four (4) 3/8″ x 16 x 1 1/4″ UNC, hex head machine screws. Install them in the 4 cover holes and turn them finger- tight. 2. Support the Clutch during the removal of the 8 mounting bolts. 3. Remove the clutch from the flywheel.
Why does my Eaton Fuller not shift gears?
My eaton fuller autoshift suddenly will not go into any gears in my driveway, just shows down arrows and R or 2 (flashing) when I try to go into any gear. When i have the truck off and turn key to start position and try to shift gears i can hear the transmission shifting successfully, however once the engine is running it will not shift gears.
How big are the bolts on an Eaton clutch?
Install four (4) shipping bolts (3/8″ x 16 x 1 1/4″ UNC, hex head). Progressively tighten (no air wrenches) the four (4) shipping bolts (criss-cross pattern) until the face of the pressure plate is minimum 0.525″ (13.34 mm) below the mounting surface. 5 New Remove the four (4) shipping bolts if they have been installed
