How do you bypass Chevy anti-theft system?
How do you bypass Chevy anti-theft system?
Method 3: Insert the key into your car’s door Step 2: Turn the vehicle key to unlock the car door without releasing it. Hold the key for 30 seconds in the position. That will tell the system you have the right key, and it will enable you to be able to bypass the car’s alarm system.
How to reset PassLock reset system on Chevy?
1. Turn the key to ON and attempt to start the engine and release the key to the ON position. 2. The SECURITY light will illuminate. Wait 10 minutes until it turns off. 3. Turn the key to OFF for 10 seconds. 4. Turn the key to ON and attempt to start the engine.
Can You disable the PassLock on a GM car?
The following instructions will allow you to disable the PassLock security in quite a few GM Vehicles. •This will allow you to install a remote starter and not have to purchase a bypass. •Avoid Costly repairs for an already broken PassLock System.
Where is the PassLock switch on a Chevy?
The switch allows the car’s passlock system to be switched on or off by splicing with a yellow wire that’s plugged into the cylinder lock. Once completed, the new switch should be placed underneath the dash right below the key hole.
What’s the name of the security system on a Chevy?
[1] Well, Passlock should be called the Great Immobilizer because not only does it stop thieves with no keys, it also stops owners with the right keys. GM introduced many security systems – VATS, Passkey, Passlock, but if your GM has a key without a chip in it, chances are it’s passlock.
1. Turn the key to ON and attempt to start the engine and release the key to the ON position. 2. The SECURITY light will illuminate. Wait 10 minutes until it turns off. 3. Turn the key to OFF for 10 seconds. 4. Turn the key to ON and attempt to start the engine.
The switch allows the car’s passlock system to be switched on or off by splicing with a yellow wire that’s plugged into the cylinder lock. Once completed, the new switch should be placed underneath the dash right below the key hole.
The following instructions will allow you to disable the PassLock security in quite a few GM Vehicles. •This will allow you to install a remote starter and not have to purchase a bypass. •Avoid Costly repairs for an already broken PassLock System.
Why did General Motors start the PassLock system?
Aug 1st, 2005 The PassLock system was designed to prevent vehicle theft by disabling fuel to the engine if attempts are made to start the vehicle without the correct bitted key. PASSLock increased the level of security while retaining the ease of service and costs offered by standard ignition lock systems.
