How do you adjust the Fontaine on a fifth wheel?

To obtain a proper setting, turn the wedge stop rod clockwise to reduce the gap and counter-clockwise to increase it. Adjust until the free travel is 1/4”. This will ensure that the automatic slack adjustment feature of the Fontaine Fifth Wheel is functioning properly.

How do you adjust a 5th wheel pin box?

You can do this work by raising the trailer from 2-3 inches conducting the landing gear on the fifth wheel. Then pull the truck back until the trailer is clear from the pin plate. The back of the pin box falls to the truck’s bottom. You may wish the bed to be covered by a piece of wood.

How much play can a fifth wheel have?

There is normally a little play between the jaws and the king pin, 3/8 inch to 1/2 inch is a normal amount of play. Unless you have a cushioned pin box you will experience what you are describing.

What is a no tilt Fifth Wheel?

The no-tilt convertible fifth wheel is designed for use with both framed and frameless dump trailer applications. When the pivot stops are engaged the topplate is rigid and does not articulate. This configuration is used for frameless dump trailers where the articulation is provided in the trailer upper coupler.

What should the wedge stop rod be on a Fontaine fifth wheel?

clockwise to reduce the dimension and counter-clockwise to increase it. Adjust until the free travel is 1/4”. This will allow the automatic feature of the Fontaine Fifth Wheel lock to function properly. Warning: Turning the wedge stop rod in too far (clockwise) will cause premature lock wear.

What do you need to know about Fontaine fifth wheel?

Fifth wheel experts can answer your maintenance and repair questions and show you how to extend the product life cycle. Sales training. Whether you need help spec’ing a fifth wheel for a new truck or assistance with questions on your parts counter, the Fontaine Studio is a great resource to help maximize your fifth wheel sales potential.

Where is the Fontaine fifth wheel in Jasper AL?

Fontaine Fifth Wheel. 3520 Industrial Parkway. Jasper, AL 35501. Phone: 800.874.9780 • 205.847.3250. Fax: 800-445-6130. Spanish (Mexico) French.

What do you need to know about fifth wheel?

Maintenance training. Fifth wheel experts can answer your maintenance and repair questions and show you how to extend the product life cycle. Sales training.

What’s the adjustment procedure for a Fontaine fifth wheel?

fifth wheel should be serviced to adjustment procedure listed on page 19-20. Pre-service and operation Figure E Fontaine Fifth Wheel Handbook 16 ADJUSTMENT PROCEDURE 1. With the wheel in the closed position, loosen the adjuster jam nut and turn the adjuster stud counter clockwise (outward) until it is free from touching the end of the lockbar

Fontaine Fifth Wheel. 3520 Industrial Parkway. Jasper, AL 35501. Phone: 800.874.9780 • 205.847.3250. Fax: 800-445-6130. Spanish (Mexico) French.

How is the height of a fifth wheel measured?

The installed height of all Fontaine models is measured from the top of the truck frame to the top of the fifth wheel. For standard models dimension “A” is a part of the model number. For example, if dimension “A” in this diagram is 7.75 inches, it would appear in the model number as 7750 (Example: SL7AWB775024). How do I measure a fifth wheel?

How do you adjust the Fontaine on a fifth wheel?