How do I reset my juniper ssg5?

Push in the reset button for 4 to 6 seconds and then release. You will see a console message as below and waiting for a 2nd reset button push. Configuration Erasure Process has been initiated. Waiting for 2nd confirmation.

How do I reset my ssg20 to factory settings?

Using a thin, firm wire (such as a paper clip), push the pinhole for four to six seconds, and then release.
Wait for one-half to two seconds.
Push the reset pinhole again for four to six seconds.

How do I reset my Juniper SSG 140 to factory settings?

The reset pinhole is a button that resets the device to its original default settings. To use this button, insert a stiff wire (such as a straightened paper clip) into the pinhole. See “Resetting the Device to Factory Defaults” on page 32 for more information.

How do I log into my Juniper router?

How to Access a Juniper Networks Device the First Time

Connect a laptop or a desktop PC to the console port on the front panel of the device.
Power on the device and wait for it to boot.
Log in as the user root .
Type cli to start the Junos OS CLI.
Type configure to access CLI configuration mode.

How do I reset my Juniper router?

To restart the switch from the front panel:

From the LCD front panel menu push the Menu button.
When the MAIN MENU (Maintenance menu) appears, press the Enter button.
Select the SYSTEM REBOOT option and press the Enter button.
To exit the menu without rebooting the switch, press the Menu button again.

How do you reset a Juniper switch?

Reverting to the Default Factory Configuration by Using the Menu Button

Press the Menu button until you see MAINTENANCE MENU on the panel.
Press the Enter button.
Press Menu until you see FACTORY DEFAULT.
Press Enter. The display says RESTORE DEFAULT?
Press Enter.

How do I reset my juniper ssg5 password?

How To Recover Password Juniper SSG 550 Using Serial Number

Connect to the device with a console connection.
Log into the firewall using the device’s serial number as both the username and password.
A warning message will display, requesting confirmation to continue with the process.
A reconfirmation message displays.

How do I reset my Juniper firewall password?

Solution:

Press the power button on the front panel to power on the router.
When the prompt appears, press the spacebar to access the router’s bootstrap loader and type these commands:
The firewall starts up in single-user mode.
At the prompt, enter ” recovery ” to start the root password recovery procedure.

What is the default password for Juniper?

Juniper Router Login Guide The default username for your Juniper router is netscreen. The default password is netscreen.

How do you reset a juniper?

How do you restart a juniper?

To restart a specific process, first find out which processes are running by using the CLI command show system process from operational mode. In this example, we will restart the Key Management Daemon (kmd), which is responsible for running IPSec. Issue the CLI command show system process from operational mode again.