How do I change the bearings on my front wheel?
How do I change the bearings on my front wheel?
If repacking the inner bearings, you’ll have to remove the inner seal to get the bearing out and replace it with a new seal after the bearing is back in. Clean off the spindle and clean the old grease out of the hub as much as possible. Coat the spindle with new grease.
Where are the wheel bearings on a car?
This is because the front rotors are often behind the front hubs, which means that to change the rotors you have to pull the hubs off the front spindles, at which point the bearings are practically in your hand. So, if you need to do a front brake job, check the wheel bearings.
What do I need to clean my front wheel bearings?
Take the castellated nut, the spacer, and the dust cap, clean them, and put them somewhere where you won’t kick them across the garage floor. Next, take a paper towel and clean the spindle. Inspect the two flat surfaces. The bearings themselves do not actually run on these surfaces.
What’s the best way to replace a front wheel?
Use a glob of grease to coat the inner bearing race, then set the inner bearing down inside it. Take the inner wheel-bearing seal and install it as you did the bearing races, tapping it into place and taking care not to cock it, but only get it flush with the inner surface of the hub. Don’t pound it in any farther than that.
What do I need to replace my front wheel bearing?
- Wheel bearing assembly
- Breaker bar
- Jack
- Socket set
- Ratchet
- Screwdriver
- Rubber mallet
- Sandpaper
When does a wheel bearing need to be replaced?
Most wheel bearings are sealed at the factory and don’t typically require replacement until around 150,000 miles or 240,000 kilometers, but there are some cars on the road whose wheel bearings do require regular service.
How do you change wheel bearings?
To change wheel bearings, start by lifting the wheel up on a jack, unscrewing the lug nuts, and taking the wheel off. Then, remove the brake caliper, the dust cover over the rotor, and the cotter pin and castle nut behind the dust cover.
What does it cost to replace wheel bearing?
How much does it cost to replace a wheel bearing? For most vehicles, wheel bearing replacement cost is usually between $125 and $750 , and rear-wheel bearing replacement cost is usually the same as a front wheel bearing replacement. For example, you might pay between $125 to $750 at your local mechanic for both labor and parts needed to replace the wheel bearing, with a 12-month warranty, whereas a Midas will most likely charge you between $125 and $650 for the same exact service on similar
