Does the Ford Ranger have a V6 option?
Does the Ford Ranger have a V6 option?
Two different engines are offered on the Ranger. A 4.0L V6 engine making 207 horsepower and 238 pounds-feet of torque is also available. Both engines come standard with a 5-speed manual transmission or an optional 5-speed automatic.
When did the Ford Ranger get a V6?
The Ford Vulcan V6 is a 3.0L, 60° V6 engine, first introduced for the 1986 model year and originally designed to be the optional engine in the Ford Taurus and Mercury Sable. In 1991 it became available in the Ford Ranger where it replaced the Cologne 2.9 engine (which it is not related to) as the base V6 in the Ranger
What should the torque level be on a Ford Ranger?
Wipe the are clean with a rag and discard the old gasket. Mount the new thermostat and gasket to the radiator with the torque wrench. The proper torque level for the Ford Ranger is 89 inch-pounds for four-cylinders and 4.0 L V6 engines. The proper level for the 3.0 L V6 engine is between 15 and 22 foot-pounds.
When was the original Ranger engine replaced by a 4.0L engine?
The original 2.6L engine was replaced by the 2.8L, which was upgraded to the 2.9L and then finally bored and stroked to make it into the 4.0L that was used in the Rangers, Aerostars and Explorers starting in 1990. It was replaced by a SOHC engine from this same family at the end of model year 2000.
What should the coolant level be on a Ford Ranger?
The proper level for the 3.0 L V6 engine is between 15 and 22 foot-pounds. Replace the drain plug, wiring harness and engine coolant. Reconnect the negative battery cable and start the engine to check for leaks. If there are no leaks, replace the engine brush guard.
The Ford Vulcan V6 is a 3.0L, 60° V6 engine, first introduced for the 1986 model year and originally designed to be the optional engine in the Ford Taurus and Mercury Sable. In 1991 it became available in the Ford Ranger where it replaced the Cologne 2.9 engine (which it is not related to) as the base V6 in the Ranger
Can a 3.8 V6 be used in a Ranger?
You can put a FWD 3.8 V6 into a RWD application by using a RWD bellhousing from a 3.0 equipped Ranger/Explorer and a T5. Early 3.8s had plastic valve covers. Later ones have cast aluminum valve covers.
What’s the power rating of a Ford Ranger?
In 1991, it was updated with lower-friction pistons, a strengthened block, roller camshaft and other changes that resulted in a power rating of 145 hp and a torque rating of 160 ft·lbs.
Where does the Ford Ranger engine come from?
The Vulcan was a clean-sheet design using the metric system. The engine block is built by Sherwood Metal Products, the intake comes from Ford’s Essex Casting, and the engine is assembled at Ford’s Lima Engine plant in Lima, Ohio. The Vulcan is a straightforward pushrod design, with 2 valves per cylinder. Bore is 3.504 in and stroke is 3.15 in.
