Does a bad transfer case cause vibration?
Does a bad transfer case cause vibration?
Common signs include a noisy drivetrain, excessive vibrations, and oil leaking from the transfer case in all-wheel or four-wheel vehicles.
What should I do about my GMC Truck vibration?
Took the truck to the local GMC dealership and they rebuilt the front axle completely. Correctly set the pinion depth and lash, etc. They also replaced the motor mounts. Took the truck home and went through the 45-55 range again. the vibration is WAY better but it is still there. It’s worst at 47mph and gone at 51mph.
Where is the encoder motor on a GM transfer case?
Access to datastream information for GM’s NVG 246 system makes most problems simple to locate and diagnose, as our case studies demonstrate. These systems also allow bidirectional control for many outputs. The encoder motor (arrow) is mounted on the front of the transfer case and is used to lock it into 4WD.
Why is there vibration in my Silverado 4×4?
Given the vibration going away in 4×4 we thought the issue may be in the front differential. The front diff was rebuilt completely and the vibration remained. The technician put the truck on a lift and removed the front drive shaft. A coworker was in the truck while on the lift and spun the truck to the 47 mph. Shake is still there.
What is mode control on GM transfer case?
The dash buttons to the right of the air vent identify this system as an NVG 246 automatic two-speed, which means it has DTCs and scan tool capabilities. mode control is a set of normally open switches that vary the voltage supplied by the transfer case module when closed.
What kind of transfer case do I need for a GMC Sierra?
Chevrolet Silverado GMC Sierra 2500HD 3500HD with 6.6L Duramax diesel engine or 8.1L gas engine Fits 2001-2007 applications with allison transmission & 6 speed manual. Call with your VIN # or Model # (located on rear case half of transfer case) to insure we ship you the right transfer case for your vehicle. 29 spline Input Gear (Electric Shift)
Took the truck to the local GMC dealership and they rebuilt the front axle completely. Correctly set the pinion depth and lash, etc. They also replaced the motor mounts. Took the truck home and went through the 45-55 range again. the vibration is WAY better but it is still there. It’s worst at 47mph and gone at 51mph.
Given the vibration going away in 4×4 we thought the issue may be in the front differential. The front diff was rebuilt completely and the vibration remained. The technician put the truck on a lift and removed the front drive shaft. A coworker was in the truck while on the lift and spun the truck to the 47 mph. Shake is still there.
What kind of transfer case do I need for a Tahoe?
(Electric Shift) Transfer Case will fit a Silverado Tahoe Sierra Yukon 1500 from 2003 2004 2005 2006 with a 4L60E or 4L65E transmission.Call with your VIN # or Model # (located on rear case half of transfer case) to insure we ship you the right transfer case for your vehicle. 27 spline Input Gear. (Electric Shift)
