Do you need to replace transmission on 2002 TrailBlazer?
Do you need to replace transmission on 2002 TrailBlazer?
It doesn’t matter what kind of vehicle a 4L60E comes in, they all have the same gearing in them, so if you are looking to replace your 2002 Trailblazer’s transmission, you don’t need to concern yourself with it at all. 02 Trailblazer Transmission Fluid Capacity and Type
What’s the problem with my GM 4L60E transmission?
For a complete diagnosis on your GM 4L60E Transmission problem, contact us for a Free Diagnostic. 1. Slow, slipping or no reverse: “lo-reverse” clutches are worn out, fluid leak in the reverse apply circuit, or broken sunshell.
Why is the reverse gear not working on my 4L60E?
Valve Body Issues- A bad valve body can make the reverse gear not work in the 4L60E. If the valve body ends up warped, or if the gasket fails, it’s entirely possible that the gear won’t engage. Booster Valve- A bad booster valve can leave you without reverse in a hurry. Sun Shell- A broken sun shell will cause…
What should I do if my Transman wont shift?
If the trans wont shift into 2nd or 4th gears also it is definite that the sun shell has broken. This is a very common problem with these transmissions. The onl fix is removal and disassembly of the transmission. Hi transman – thanks for the note.
It doesn’t matter what kind of vehicle a 4L60E comes in, they all have the same gearing in them, so if you are looking to replace your 2002 Trailblazer’s transmission, you don’t need to concern yourself with it at all. 02 Trailblazer Transmission Fluid Capacity and Type
For a complete diagnosis on your GM 4L60E Transmission problem, contact us for a Free Diagnostic. 1. Slow, slipping or no reverse: “lo-reverse” clutches are worn out, fluid leak in the reverse apply circuit, or broken sunshell.
How much fluid does a 2002 Chevy Trailblazer have?
The 2002 Chevy Trailblazer has a fluid capacity of 12.1 quarts. Only if you are putting in a brand new 4L60E would you ever need to put the whole 12 quarts in. In most situations, when you change the fluid, you’ll maybe need half.
Where is the transmission fluid in a trailblazer?
Lower the front of your Trailblazer to the ground and open the hood. Locate the dipstick for the transmission fluid near the firewall on the passenger’s side of the engine compartment. Remove the transmission dipstick from the dipstick/filler tub and insert a funnel into the tube. Fill the transmission with Dextron VI automatic transmission fluid.
How to change the transmission fluid on a 2006 Chevy truck?
Raise the front of the truck off the ground with a jack. Position a set of jack stands under the front suspension to support the truck then remove the jack for now. Position a wide oil drain pan under the transmission then remove the retaining bolts from the front and sides of the transmission oil pan.
The 2002 Chevy Trailblazer has a fluid capacity of 12.1 quarts. Only if you are putting in a brand new 4L60E would you ever need to put the whole 12 quarts in. In most situations, when you change the fluid, you’ll maybe need half.
Why is my Trailblazer 4WD light not working?
4wd light on… no response from switch, no lights on at all. Switch lights come on when ignition first turned on so I know lights aren’t burned out. Checked fuses, all good. Disconnected battery, unhooked TCCM. Codes b2725, c0306 and c0550 Dealer tells me switch, TCCM and encoder all bad… $1100.00 fix. Really… all three bad!!!
What kind of transmission does a Chevrolet TrailBlazer have?
The standard Chevrolet Trailblazer has a 4.2-liter, inline six-cylinder transmission with four-speed automatic.
Are there any problems with the 2002 Chevy Trailblazer?
CarComplaints.com Notes: The Trailblazer emerged from an “upscale trim line” of the Blazer, but there’s nothing upscale about its transmission problems or its wonky, unpredictable headlights. No one has added a helpful site for this 2002 Trailblazer problem yet.
Why does my trailblazer not move in the gears?
KenF and FJ4072 thank you but KenF it’s a automatic transmission 2002 trailblazer Lt 4wd it starts fine but when I put it in reverse or drive it doesn’t move just revs and on the dash it’s saying it’s going to the gears I’m choosing but neither gear moves the truck 66 people found this helpful. Any noise from transmission, such as whining?
4wd light on… no response from switch, no lights on at all. Switch lights come on when ignition first turned on so I know lights aren’t burned out. Checked fuses, all good. Disconnected battery, unhooked TCCM. Codes b2725, c0306 and c0550 Dealer tells me switch, TCCM and encoder all bad… $1100.00 fix. Really… all three bad!!!
