Do you need to remap fuel injection after new exhaust?
Do you need to remap fuel injection after new exhaust?
With just a setup of pipes installed, it is not imperative to remap the fuel curve as it will not run lean enough to cause any damage. If you were to purchase an exhaust that is similar in size, shape, volume, and design then remapping the fuel injection may not be necessary.
How to remove an exhaust air supply tube?
Use a boxed end wrench to loosen these bolts and nuts. Once the bolts and nuts have been removed, push the line aside. Step 7: Remove the smog pump connection. Use a boxed end wrench to remove the other bolts that hold the exhaust air supply tube to the smog pump. You can now remove the old exhaust air supply tube.
Do you need a fuel management system for new exhaust?
Before you buy a intake or a new set of shiny exhaust get yourself a fuel management system as this is necessary for the proper function of your ride. I use a vance and hines fuelpak and its the best purchase I did for my bike and this avoids a dynotune every time I do a simple upgrade.
What should I do if my fuel pipe is damaged?
Make sure any clips are correctly positioned. Do not overtighten them, particularly when they are wire clips, for these can cut through a hose. When a metal connector needs replacing, the pipe is generally damaged as well as the connector. If there is enough pipe, you can cut off the damaged section.
How do you replace a fuel pump in a car?
Connect the line to the fuel pump, and then reattach the other end to the carburetor. Use a wrench to hold the fuel pump fitting and tighten the line nut with another wrench. Attach the fuel inlet hose from the gas tank and the vapor-return hose. Tighten all clamps. Reconnect the battery ground cable, start the vehicle, and check for leaks.
Use a boxed end wrench to loosen these bolts and nuts. Once the bolts and nuts have been removed, push the line aside. Step 7: Remove the smog pump connection. Use a boxed end wrench to remove the other bolts that hold the exhaust air supply tube to the smog pump. You can now remove the old exhaust air supply tube.
When was the last time I replaced a fuel pump?
On the other hand, a repair job that goes awry can lead to frustration, swearing and bloody knuckles. The last time I replaced a fuel pump, I tackled the job outside, on the ground in the middle of a dust storm. Because the fuel tank had to be dropped to access the pump, the process took a couple of hours.
What to do if you spill gas on your fuel pump?
Disconnect the fuel tank hose at the fuel pump and plug the hose with a bolt or wooden dowel to keep any fuel from flowing out. Also, disconnect the vapor-return hose if the vehicle is equipped with one. Be sure to wipe up any gas that spills.
