Do you need slide hammer to remove rear axle?
Do you need slide hammer to remove rear axle?
You need a slide hammer to remove the axles from this type of rear end because of the interference fit between the axle bearings and the housing and the parts’ age. Other types of rear differentials use different retention methods and may not require this. Watch out for the loosened brake assembly.
How do you remove rear axle from differential?
Using a small screwdriver or magnet work the metal “C” clip in a circular motion, This will enable you to remove the clip which will release the axle from the differential. This can take a little time so hang in there.
When do you need to replace an axle shaft?
If this happens, you need to replace the axle shaft because it creates a stress riser in a critical area, and the axle will probably break in this area. Using a hammer and chisel, solidly strike the ring at the drilled section. If you support the other side of the ring with a block of wood you can hammer away.
What happens when you remove an axle on a Ford?
This is probably the biggest deterrent to most owners when removing an axle as the brake lines may be excessively corroded and the head of the brake fitting may strip. The parking brake cables may require you to disassemble the brake hardware and shoes to release the cable from within the backing plates.
How do you remove the rear axle from a jeep?
If you forgot your penetrating oil at home use anything handy like transmission fluid or brake fluid. Remove the shock bottoms with a ¾” socket. Remove the rear driveshaft end from the axle with an 8mm socket wrench and a screwdriver to hold the shaft from spinning.
If this happens, you need to replace the axle shaft because it creates a stress riser in a critical area, and the axle will probably break in this area. Using a hammer and chisel, solidly strike the ring at the drilled section. If you support the other side of the ring with a block of wood you can hammer away.
What happens when you remove the nuts from an axle?
The rectangular shaped steel plate under the nuts holds the axle shafts and bearings in the housing. Once the nuts have been removed, you can lightly pull the plate loose. It is still trapped on the axle shaft, but you need to make sure it is loose.
Do you need to clear the axle housing?
The axle shafts need to clear the axle housing to be fully removed. If you are going to perform a standard rebuild, which means replacing bearings, seals, and clutch pack, it is imperative to take good notes of the shims’ locations so you can return the axle back into service with minimal adjustments required.
