Do you need a pinout for a 97 Blazer plug?
Do you need a pinout for a 97 Blazer plug?
This pinout matches my 97 blazer plug perfect, however I really need one for my 95 s-10 pickup. It is not labled with numbers like that one though it uses the alphabet A-Z. 95-97 use the same clusters. The only difference is the tachometer calibration between 4-cyl and the 6-cyl.
What kind of spark plug does a Chevy S-10 use?
A Chevrolet S-10 spark plug needs to be as reliable as the rest of your truck. Every quality plug from AutoZone has an insulated passageway for high-voltage signals to travel down before it jumps the gap and goes into your engine block. Precision is important in the work you do, and the same holds true for the inner workings of your S-10’s engine.
Why does my 1994 Chevy S-10 not start?
1994 Chevrolet S-10 4.3 tbi. I never get the signal to turn on the fuel pump or fire the injectors but if i poor gas in the intake once the truck starts it runs fine. Any ideas ? I have replaced the fuel pump relay oil pressure switch and computer.
What’s the problem with my Chevy S10 4.3?
I have this same problem with my 99 s10 4.3. the code reader says miss fire cylinder #2… so I replaced wires, plugs, distributer cap and rotor. after 2 days this problem got worse. again I read the codes and it read the same code, cylinder #2. good old GM I guess 71 people found this helpful.
Where is the spark plug on a S-10 Blazer?
Remove the plug wire from a spark plug, leaving it attached to the distributor cap (or coil pack on S-10s with distributor-less ignition systems) and turn the ignition key to the “Start” position. A bright spark should cross an inch or more to the engine block.
How to troubleshoot a Chevy S-10 Blazer ignition system?
Attach the black (negative) and red (positive) clips on the tester to the battery. Turn the key to the “Run” position and touch the probe end of the tester to the two wires on the coil by inserting the probe into the back of the electrical connector.
Why does my Chevy Blazer have no power?
If not that code then your problem is most likely the cheap plastic distributor that GM installed for that year. Take off that expensive cap and see if the shaft jiggles. It is better to remove the distributor to inspect it. AutoZone sells a lifetime warranted Distributor for about $90.
Why does my Chevy Blazer engine bog down when I hit the gas?
Take it to a good local mechanic (not a dealer) and see if this is one problem. My Blazer bogs down when you hit the gas and has trouble starting. We have replaced the MAF sensor, plugs, rotor, cap, plug wires, and fuel filter. The fuel pressure is at 50psi when idling and 64 wot when driving.
