Easy tips

Do you need a new transfer case control module?

Do you need a new transfer case control module?

A NEW OR USED REPLACEMENT MODULE MUST BE REPROGRAMMED FOR YOUR VEHICLE. WE PROGRAM, OFF THE CAR, NEW AND USED TRANSFER CASE CONTROL MODULES WITH THE LATEST GM SOFTWARE UPDATE THAT FIXES SOME OF THE 4WD LOW ISSUES AND FAULT CODES.

What are symptoms of bad transfer case control module?

If the shift is not possible, the selector switch will come on and flash for 30 seconds. Locating the TCCM is not tough. Will BMW End the Production of Manual Cars? Symptoms of a bad TCCM are likely to include flashing a warning message or turning on a warning light on the Driver Information Center (DIC).

What is mode control on GM transfer case?

The dash buttons to the right of the air vent identify this system as an NVG 246 automatic two-speed, which means it has DTCs and scan tool capabilities. mode control is a set of normally open switches that vary the voltage supplied by the transfer case module when closed.

What should I change in my 4×4 transfer case?

The two common failures in the 4WD system is the shift motor, and the control module. I went ahead and replaced the shift motor. This may seem like an expensive part, but you can actually get a new transfer case shift motor from Rock Auto for $64.00. For that price, I went ahead and just replaced it.

What are the signs of a transfer case problem?

3 Symptoms of Transfer Case Problems Trouble Shifting Gears One of the most immediate and troubling signs of transfer case problems involves difficulty in shifting gears. Unusual Grinding Sounds The output shaft seal doesn’t just keep fluid inside of your transfer case – it also acts as a seal for the sounds produced by the Erratic Four-Wheel Drive Performance

What does a transfer case module do?

The Transfer Case Control Module (TCCM) is a specialty of the General Motor ’s 4WD operation. It controls the electronically-operated 4-wheel-drive system. All of its functions involve the shift – processing the shift request, executing it, and verifying the completion.

Where is the transfer case control module located?

The Transfer case control module is located on the RH side of the Cab under the glove box on the floor.

What is a transfer case module?

The Transfer Case Control Module (TCCM) (Transfer Case Control Module (TCCM)) is a microprocessor-based assembly, controlling the 4X4 transfer case shift functions via the actuation of a shift motor and utilizing the feedback of a mode sensor assembly. Communication is via the PCI serial bus.

What happens when transfer case control module is in sleep mode?

The Transfer Case Control Module (TCCM) has not received the wake-up call during key-up and has remained in the “sleep mode”. When the TCCM is in the “sleep mode”, it will not communicate with the class II bus or the Tech 2®. 1. Try to communicate with the TCCM. If no communication, go to step 2.

What to do if transfer case switch does not work?

You have to move onto examining a couple of circuits if the indicators don’t flash. Go on checking the battery positive voltage and ignition voltage. You also have to diagnose the connector of the transfer case shift control switch and the ground circuit for ground.

Author Image
Ruth Doyle