Easy tips

Can I install a fuel pump?

Can I install a fuel pump?

Installing a fuel pump can be difficult – especially if you’ve got a full gas tank. Plus, because fuel is flammable, the task can be dangerous. If you decide to tackle the job yourself, make sure to take the necessary precautions and have a fire extinguisher on hand.

How to install a fuel pump in a car?

• To ensure proper installation, align the fuel pump lever with the cam in the engine. Misalignment may cause damage to the new pump. • On models with a push rod, apply grease or petroleum jelly to hold rod in the retracted position. • Install gasket and spacer (if required) and mount fuel pump to the engine.

What should I do if my fuel pump slides out?

Make sure that push rod is correctly installed in both the engine and the fuel pump. If the push rod slides out, you can pack it with some heavy grease to hold it in place while you install the pump. Attach the fuel outlet line that runs to the carburetor.

What should I wear to replace my fuel pump?

Replacing your fuel pump is a messy job, so be sure you’re dressed appropriately. You will also need some common tools, as well. Remember, you will be working around fuel and fuel vapors, so be sure that your workspace is well ventilated.

Can a broken fuel pump be replaced at home?

But like any of your car’s components, mechanical parts can wear down or break. Fortunately, replacing a broken fuel pump is a fairly simple task that you can accomplish at home in about an hour or two. Replacing your fuel pump is a messy job, so be sure you’re dressed appropriately.

How do you install an electric fuel pump?

Place assembly upside-down on bench. Place rubber insulator on inlet of pump. Install pump and coupler in same manner as removed, pushing downward on pump while fitting inlet into mounting bracket. Seat rubber insulator and pump securely in mounting bracket. Tighten both clamps securely, if applicable.

Make sure that push rod is correctly installed in both the engine and the fuel pump. If the push rod slides out, you can pack it with some heavy grease to hold it in place while you install the pump. Attach the fuel outlet line that runs to the carburetor.

How do you remove a fuel pump from an engine?

• Remove fuel pump to engine bolts and properly dispose of pump. • Remove the old mounting gasket from the engine block and clean the surface. • Inspect spacer for cracks (if required) between pump and engine block. • Some models may use a push rod to activate the pump (see figure 3 and 4).

Where is the best place to mount a fuel pump?

Mount the fuel pump close to the existing fuel lines and tank, but away from any exhaust system component. Place the pump and bracket assembly as near to the bottom of the fuel tank as possible, but never more than 24 inches above the top of the tank. 3. Remove a section of fuel line where the pump is to be mounted.

Author Image
Ruth Doyle